Light flashes 10 times then pause then 10 times
You should be able to disconnect the battery for a minute or two and clear the code if you think it is fixed.
SOURCE: 05 ford expedition air bag light flashes
Time to take the vehicle to your local Ford dealer to have the system diagnosed and have the needed repairs completed. Do not try to fix the system yourself as you may deploy the sir bag by accident and injury may occur. Not to mention that replacement of an air bag is very expensive. Let the techs that are trained to deal with these systems take care of the problem for you.
SOURCE: Air bag light on 2000 Mercury Sable
it can be two things the gas is low in the air bag or the sensor itself inside the front bumper is sticking
SOURCE: i need to change my starter on a 1991 mercury sable
Starter are one of the easier mechanical engine parts to change.
1) DISCONNECT THE BATTERY.
2) Disconnect the electrical cable running to the solenoid on the starter.
3) Remove the two bolts holding the starter in place.
4) Pull the starter out.
To install another starter, do the above steps in reverse order in reverse.
SOURCE: Air bag light blinks 4 times then pauses then 4
Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.
Just push it together properly and it should clear the AirBag fault
SOURCE: How do I fix a code 44 problem? Air bag light
The air bag code 44 indicates that the air bag computer is not receiving a signal from the right front air bag sensor. This could be caused from defective wiring (loose wire or grounded through chafing) or the sensor being defective.
Testimonial: "Thanks. That is what was wrong; my husband finally checked with the dealer."
293 views
Usually answered in minutes!
Can i reset it to see if that works. It flashes 10 times then pauses ,flashes 10 times and pauses. I want to get the air bag working at a reasonable cost.Help!
×