Electrical i have a 94 toyota 4 runner it doesn't have dash lights when the key is turned nothing at all but my 4 way flashers work and my headlights work. but nothing else.

check battery, also alternator

What works? Just headlights? Does anything electrical work that does not need the ignition switch to be in the on position? Possibly four way flashers, brake lights, horn, interior light, dash lights in instrument panel as well as headlights should all work without the key in the ignition and in the acc or on position. If this is what you have, then I would say you need to replace the ignition switch.
Hope this helps.

You probably have a ground issue , looking at a wiring diagram or ground distribution diagram to see if these share a commom ground point or share power from same fuse,https://www.youtube.com/watch?v=WoN1nou5t1Q&t=224s circuit with a high resistance problem . Do you know how to test automotive electrical circuits with a DMM - digital multi-meter , how to read an use a wiring diagram to pin point test spots in a circuit . Free wiring diagrams at http://www.bbbind.com/free_tsb.html . Check out these videos on voltage drop testing an basic electrical testing . This is the way to find electrical problems .
Mastering Voltage Drop Testing with Pete Meier and Jerry Truglia YouTube
Electric Testing Techniques You Need to Know

Basic Electricity for Service Techs Ohm law Current Flow Opens Shorts

good luck !

check under the steering wheel
or
http://www.bimmerfest.com/forums/showthread.php?t=726151

Yes your right the emergency flasher switch is the flasher and located in the middle of the dash and it has a triangle on it with a point up and a ! in the middle. It's dark red in color and when depressed lights up red and flashes ( if it's working like it's supposed to ) If the fuse for hazard is blown the flasker won't work on turn singal either. The fuse for the hazard is hot all the time and the turn fuse is only on with the key. You might find that when you find the button and push i thaqt the turn signals work normally and after you find why the flashers doesn't work on hazard then the hazards will work too.
with the hazard switch poped out of the dash ( it just pries out) it'll have lot's of wires one will be hot all the time and another will become hot when you turn the key on. the other wires go to the turn signal switch. If you find that the switch works fine and it still does flash on turn but it does flash on hazard with it on as a hazard go around and look at all of the lights. They have to work on both the frontand the back and the indicators in the cluster ( speedometer head ) If they all work and are bright ( not dim light the running light) The hazard switch is bad as it's the flasher is made into it.

1993 Toyota Truck 4 Runner 4WD 3.0L FI 6cyl the Flasher is located: Front seating area, driver side, under dash, mounted driver side of steering column

Hope helps.

Toyota Pick-ups, Land Cruiser, and 4 Runner 1997-00
Flashers -REPLACEMENT

The turn signal flasher is usually located in the convenience center, under the dash, on the left side kick panel. In all cases, replacement is made by unplugging the old unit and plugging in a new one.

Hope helped with this (remember rated this help) Good luck.

look under the dash on the driver side look for button, (valet switch) press button and then crank.

You have a bad alternator.

you have a back break light out