20 Most Recent 1993 Subaru Impreza Questions & Answers

Time to have the vehicle towed to your local certified mechanic for diagnosis and repair.

1993 Subaru... | Answered on Feb 28, 2018

If it's quiet enough, turn the key to the "on" position without cranking it, then stop and listen for a humming or buzzing sound. If you don't hear it, your fuel pump may be having issues.

1993 Subaru... | Answered on Jan 04, 2018

check and see if seal is damaged then try to push the axle back in you may have just popped out the axle from transmission if your lucky

1993 Subaru... | Answered on May 05, 2017

wheel bearing will rumble

treads on all 4 tyres matching?
correct pressure
fauty wheel sensor that side
seized/leaking caliper piston or pads worn
a flat spot on damaged side tyre
lost a weight dammaded rim /mag
strut or bush damage

1993 Subaru... | Answered on Mar 11, 2017

Check for spark , do you know what that is ? Pull a plug wire off at a spark plug an hold need engine ground (Metal on the engine) have someone crank over the engine .Is there spark ? If there wasn't any spark it would seam like same thing How to troubleshoot no spark condition with test light Subaru

1993 Subaru... | Answered on Jan 03, 2016

Possible fuel pump. Need to check for spark and fuel pressure.

1993 Subaru... | Answered on Jan 03, 2016

1993 Subaru Impreza Won't Start! - NASIOC

forums.nasioc.com > ... > NASIOC Technical > Service & Maintenance
Sep 12, 2004 - 3 posts - ‎3 authors The car has been running fine, but recently in the morning especially, it won't turn over. I crank it and its trying to start, but there is no spark. Car won't start, cranks but no start. - NASIOC - North ...
19 posts
Aug 26, 2013
car wont start, getting fuel and spark - NASIOC - North ...
5 posts
May 22, 2012
HELP: Car won't start after timing belt change - NASIOC ...
19 posts
Sep 23, 2008
Weird starting problem--1993 Impreza - NASIOC ...
9 posts
Mar 4, 2003
More results from forums.nasioc.com

my 1993 impreza wrx wont start please help - ClubWRX.net

Dec 5, 2009 - 7 posts - ‎2 authors can anyone help me, my 1993 impreza wrx wont start, 2 days ago i went to ...ClubWRX Forum - Subaru Impreza WRX and STi Community and ...

1993 Subaru... | Answered on Oct 24, 2015

Lock cylinders are attached on the inside of the door with a clip. Remove the door card then the retainer for the lock rod. The body clip just slides out the side. Then you can push a fresh clip on http://thumbs.ebaystatic.com/d/l225/m/mNfX1-Te6xNF1e1CaSdEnXQ.jpg

1993 Subaru... | Answered on May 20, 2015

connect power to one side and ground to the other side

1993 Subaru... | Answered on May 20, 2015

Could be all sorts of things. If the timing belts have slipped, the engine will usually not start or run really rough. Could be the crank angle sensor (under the alternator, just above the main pulley).

If the belt has slipped, you can check by pulling the cam belt covers off. Usually its the LHS side belt that's jumped. The hydraulic tensioner sometimes works loose and detensions the belt. Rotate the engine till to top dead center on the pulley, and see if the cam pulleys are at the timing marks. If the belt has slipped, you WILL have bent valves.

1993 Subaru... | Answered on Feb 24, 2015

The problem is uncombusted fuel. Can be caused by timing error (cam or crankshaft sensor), failing spark plugs,a faulty ignition coil (quite common). Go for ignition problems first. Check or change spark plugs and substitute ignition coil (I found one at the wreckers).

1993 Subaru... | Answered on Feb 16, 2015

1st get a new air filter I recommend a quality brand like the oem one or purolator.
2nd remove and clean the maf sensor. Start with the screw clamp on the intake hose. Then unplug the sensor just squeeze the tab and wiggle it off. Now remove the 4 - 10mm boltsthat hold the maf sensor on the air box. Use caution as some models have a housing with brackets that are loose when the above 4 bolts are removed.
Next clean the air flow sensor using crc maf cleaner or other maf sensor safe cleaner. This is necessary as the sensor gets dirty as the miles accumulate. Make sure the sensor wires are very clean and let it fry for 30 mins before re-installing the sensor.

I would inspect the blower motor for debris as a 93 impreza doesn't have a cabin filter.
You can access the hvac fan from under the glove box see the attached video for how to. I know its not the correct subaru but the procedure is the same. misfire-backfire-not-accelerating-tq5sh21jzhkdedjt044n20r3-4-0.jpg

1993 Subaru... | Answered on Jan 30, 2015

Test plug leads with a Ohm meter, when the resistance is higher then 8k Ohm, replace them, check also the coil for traces of arcing out. Check spark plugs cq replace them.

1993 Subaru... | Answered on Dec 01, 2014

Clean your IACV and throttle body butterfly valve, get throttle body cleaner at any auto parts shop.

1993 Subaru... | Answered on Nov 30, 2014

sounds like fuel delivery problem, have pep boys tell you what codes are if you dont have diag tool. if its fuel pump, easy fix, under car, not in tank

1993 Subaru... | Answered on Jul 22, 2014

Not finding what you are looking for?
1993 Subaru Impreza Logo

246 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Subaru Experts


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14866 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6576 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Impreza Subaru

  • Impreza Subaru

Most Popular Question

1993 subaru impreza engine problems

  • Cars & Trucks