2006 Citroen Berlingo 1.9d - Answered Questions & Fixed issues
Citroen speedometer pulse
It is above the drive shaft output from the gear box for the right hand wheel. (from the drivers' seat) or...looking under the bonnet: observe the two drive shafts entering the final drive of the gearbox: You will see an electrical plug above the driveshaft on your LEFT.(The RPM pick-up is at the top of the bellhousing, immediatley above the flywheel ring gear.)
11/2/2013 12:47:28 AM •
2006 Citroen...
•
Answered
on Nov 02, 2013
•
385 views
Hi. I need a picture for the timing marks on a
There is only 1 mark on the cam shaft which alines with a hole on the head that will give you valves 1+2 rocking. Then you remove a spark plug on piston 1 and find TDC top dead center ( when the piston is on it's highest point.Thats the only way.
8/15/2012 8:20:33 PM •
2006 Citroen...
•
Answered
on Aug 15, 2012
•
1,034 views
Hi I need a pic for the timing on a berlingo 1.4
Hi,There is a site that can provide you with specs, service manuals and just about else concerning your Berlingo.
CLICK HEREI trust this will be of assistance. I have no personal interest or association with any product that I may suggest.
7/20/2012 7:21:56 PM •
2006 Citroen...
•
Answered
on Jul 20, 2012
•
1,064 views
Citroen berlingo crankshaft pully layout
Citroen has timing hols where you can put a 8mm bolt in the pulley and a 6mm in the crank to lin them up check this pdf on timing. it'll help From Shawn Howell http://www.search-document.com/pdf/1/citroen-berlingo-timing-marks.html
11/2/2013 12:55:43 AM •
2006 Citroen...
•
Answered
on Nov 02, 2013
•
1,199 views
Hello I have a 2001 citroen berlingo multispacer forte 1.9 diesel I cannot find where the cabin filter is if you can help thankyou
The pollen filter in mounted inside the car in the passenger side footwell. Remove the lower kick panel. It is held in with push clips that can be gently hooked out with a screwdriver. Once the panel is out there is a black plastic casing up under the dashboard. There should be a long rectangular cover that will slide sideways and come free. This should reveal the filter. Slide the old filter out noting which way around it is and slide in the new clean filter. Replace the slide panel, refit the kick panel and push the retaining clips firmly until they click into place.
Losing power on LPG. Seems to run fine for a
Wiring, schematic, electrical diagrams, fuse diag, error codes, torque settings etc are basic contents of these online books they have here on this website www.reliable-store.com I have attached. Must check it out
Not finding what you are looking for?