The stereo will not work and the wipers do not work there is a display of eco-mod on the display

Replace the gem module / fuse box that houses the fuse for wipers under driver side of dash. As it most likely burned up a circut path in the box enough to not let low power thru....possiable bad wiper control or partial failed wiper relay.

Sounds like it could be a bad ignition switch-the electrical part, not the lock cylinder. When key is in the on position (run), those fuses should be powered. Are all the maxi-fuses good? They distribute power throughout the car's electrical circuits-like the fuse panel, for instance, so check the maxi-fuses. If good, probably the ignition switch is bad.

You need to see the dealer and have the Body Control Module scanned for fault codes.

Similar issue on my 2013 taurus. Died on me one day and wouldn't even crank. Advancetrac Service, 911 assist unavailable, sometimes braking system faults and just about every light on the dash illuminated. No codes. The problem was the Run/Start relay (Start/Run??). Swapped it with the windshield wiper relay to verify. Car started but the wipers didn't work. Replaced the Relay for $25 from AutoZone.

Hello
The engine and transmission in this cars drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL THE DIAGNOSIS & TESTING IS COMPLETED.

other than a complete rewire(new looms)not much.... labour costs mould be outrageous.......

you have a module problem you need to have your vehicle electronically scann to find them

I have ML350 SE and my front wipers stopped working overnight (back wipers are working ok). I changed the fuse but it did not help.

check your charging system the voltage at the battery should be 12.85 Volts WITHOUT the engine running and 13.2-14.5 Volts with the engine RUNNING. If the voltage is low it probably means the alternator is at fault.

The Generic electronic Module controls the windshield wipers, this system controls all the electrical items like windows door ajar warning and so on. You need to have the GEM quick tested to determine the area to look for the fault, it is very rare for the GEM to fail, the most ccommon cause is the W/S wiper switch, and next the motor's internal contacts that switch it on, or the motor itself, get the Generic Electronic Module (GEM) tested with a scanner and then get back to me with the fault codes, if I was to guess a part it would be the wiper switch it is fairly expensive so it's better to test first then replace parts after pin-point tests of components and wiring are complete and you can be sure with little room for error what is causing the problem.