Question about 2006 Citroen Berlingo 1.9d

1 Answer

How to bypass an immobiliser on a citroen berlingo van

I put in new key barrell but the immobiliser isnt regognising is there anyway at all i can cut a cable to bypass it or anything really stuck would be so grateful

Posted by Dean Gordon on

Ad

1 Answer

A. Bayangs

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 278 Answers

Try using the old key and place it near the barrel then turn the new key. These keys have RFID that the immoblizer can detect. Once key is changed, it will still look for original key to disable immo.

Posted on Oct 06, 2014

Ad

5 Related Answers

alicantecoli

Colin Stickland

  • 22485 Answers

SOURCE: how to remove a citroen berlingo dash board

Not very difficult once you disconnect the battery ,then remove the steering wheel and work from their following your nose for the screws ,i think the fittings that hold it in place and the heater unit are on the engine side of the firewall so you have to remove the wiper motor and the plastic trim below the screen .This is a lovely job to do and i dont envy you on this just done a peugeot 306 heater core still have the scratches all over my hands

Posted on Feb 27, 2012

Ad
shawnhowell1

Shawn Howell

  • 9 Answers

SOURCE: citroen berlingo crankshaft pully layout

Citroen has timing hols where you can put a 8mm bolt in the pulley and a 6mm in the crank to lin them up check this pdf on timing. it'll help From Shawn Howell http://www.search-document.com/pdf/1/citroen-berlingo-timing-marks.html

Posted on Jul 20, 2012

shawnhowell1

Shawn Howell

  • 9 Answers

SOURCE: black smoke while driving my citroen berlingo van

It can be oil rings. It can be valve seals or it can be you fuel mixture. Sounds like worn rings.

Posted on Jul 21, 2012

Jonah Oneal

  • 14092 Answers

SOURCE: Citroen berlingo when i turn ignition on only oil and air-bag light comes on i put a cd player in the other day and i sparked ans smoked any ideas wot i have done is it a fuse

take vechicle to garage if you see airbag light flashing, sound like you have a electrical problem if you see smoke sparks something shorting out.

Posted on Sep 16, 2012

SOURCE: Red light with wave like squiggles under

stibilty control and or traction control check owners manual

Posted on Sep 27, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My van has been revving up and down for 2 days and would cut off while driving and now wont start.


The first thing you need to do is run a fault code test through the diagnostic connector under the dash.

Jun 20, 2016 | Citroen Cars & Trucks

1 Answer

How I find were the starter motor fuse is on my Citroen berlingo van 2007 model


http://www.citroendriveeurope.co.nz/wp-content/uploads/2013/10/Citroen-Berlingo-Owners-Handbook.pdf

Oct 20, 2015 | Citroen Cars & Trucks

1 Answer

Market value 1983 citroen berlingo 2 door van. Manual


The Citroen Berlingo is produced by the PSA Peugeot Citroen alliance since 1996. So in 1986 it would be C15, not Berlingo.

Aug 07, 2015 | Citroen Cars & Trucks

1 Answer

FIND CORRECT TYRE PRESSURE FOR A CITROEN BERLINGO VAN


See if this helps. In the U.S. the tire info is posted on the door frame of the driver's door. The link below lets you input exact info from your car and gives you Michelin's numbers. Pretty neat.




Looking for new tyres

Feb 11, 2015 | 2008 Citroen Berlingo Multispace

1 Answer

Can u please help i spent all my money on a citroen berlingo the man was sarting with a screw driver soimanaged to get a barrell but now wont start with immobiliser can i snip a cable too buy pass this i...


You will need the old key. If you have it tape it to the new barrel each key has a chip to tell imobeliser its correct the old key taped on the barrel is the only way

Aug 08, 2014 | 2004 Citroen Berlingo 1.9

1 Answer

How to bypass an immobiliser


Check for a ring that fits outside the ignition barrel cover. It is usually connected to to two wires. Try removing it before you insert the key.

Aug 07, 2014 | 2004 Citroen Berlingo 1.9

1 Answer

Immobiliser faults


HI
I hope that you still have the old key.
all you have to do is that: open up the old key/remote and look inside it for a small black rectangle piece, this is the immobilizer chip.
remove it carefully don't brake it, and place it inside the new key/remote, put a little glue on it

good luck

Feb 24, 2014 | Cars & Trucks

1 Answer

Where is fuse infuse box for fan heater in citroen berlingo van 2002


On this website you find fuse box diagram and description for Citroen Berlingo

Berlingo CARKNOWLEDGE

Nov 23, 2012 | Cars & Trucks

Not finding what you are looking for?
2006 Citroen Berlingo 1.9d Logo

2,157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Citroen Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14842 Answers

Are you a Citroen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...