Yamaha HTR-5990 Receiver While adjusting the speaker levels using the onscreen menu, My receiver quit recognizing the surround speakers. Troubleshooting steps taken: Checked connections at unit. ...
...power either by car charger or mains but i can not turn it on it was fine last night leave on charge for two hours, then with the SD card out hold down the reset button at the back of unit for ten ...
...Yamaha receiver you listed is region free, therefore I assume you are talking about a different unit, in that case give model please. If you have the problem with a Yamaha RX-V661, then simply ...
Question about PIXMA MP150 All-In-One InkJet Printer
second until the display shuts off. Wait ten seconds, press power button - allow machine to completely turn back on. Otherwise, they say your printer may need repair. (If holding the power button will
...not recycle power during the reset procedure. When it says hold for about 10 seconds, don't hold for more than ten seconds or the procedure will likely fail, if ten seconds doesn't work try 5
...yamaha receiver htr5730 http://www.retrevo.com/support/Yamaha-HTR-5730-Receivers-manual/id/1075bh230/t/2/ Page 52 1 Hold down STEREO on the Front Panel "Factory Preset" appears on the front panel 2 ...
...Yamaha RX V671 receiver, resulting in it not turning on. Here are a few things you can try to troubleshoot the issue: Check the power cord and outlets: Make sure the power cord is securely plugged ...
...yamaha rx-v671 receiver? If there is no apparent cause for the protection mode activating (such as shorted speakers, burning smell, blown fuses, lighting strike or mains power surges), reset the ...
...button at rear, but refuses to reset. Power-on the router. Push the button, and hold for ten seconds. Power-off the router. Push the button, and hold for ten seconds. One of the above should reset
Question about Barricade g SMC2804WBRP-G Wireless Router
...receiver To perform a factory reset on a Yamaha RAV 352 remote for use with an RX-V2500 receiver, follow these steps: 1. Turn on the RX-V2500 receiver using its power button or remote control. 2. On ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions
