Question about MultiSync VT45 Multimedia Projector
NEC VT45 projector There is a flashing red light on our school's VT45 projector. The lamp has been replaced but the flashing red light remains. Any suggestions to try? make sure the doors are shut all
Question about VT47 Multimedia Projector
...NEC VT47 placing this Lamp into the (1st) projector that had failed to power up. The problem is that the other lamp did not reset the lamp red light plus the system still will not power up also will ...
Flashing red light Sometimes when I start up the Cinego, the projector's power button immediately or within a few seconds starts flashing red. Other times it will interrupt itself while projecting, ...
...NEC if the status light is flashing .5 seconds on and 2.5 seconds off - you need to replace the lamp cover correctly. if the status light is flashing .5 seconds on and .5 seconds off in 2 - 6 cycles ...
...projector, there is one steady green light and one flashing green light. The screen will come up and appear as normal but then after about 10-20 seconds the screen turns off and a red and orange ...
Question about MT850, MT1050, MT1055, MT1056 Replacement Projector Lamp - MT50LP Projector Lamp
...NEC MT850 projector. The problem is when I turn it on. Every thing starts up but the lamp. The lamp will start lighting up but never goes to full power then it shuts off after about 3 seconds and the ...
...NEC VT 800 projector hooked up to a smartboard. When I turn the projector on the green power button will come on. Then the red status indicator light will flash 6 times. The bulb will not come on. ...
NEC vt800 projector troubleshooting I'm having problems with my projector. I changed the lamp about a month ago and reset the timer on it in the menu at that time. I have 96% life left in the ...
NEC VT676 I have tried numerous new bulb in numerous projectors. Have tried holding down "help" for at least 10 seconds to reset the bulb hours. Could these non-OEM bulbs be causing the ballast ...
Question about LT25 Bulb/Lamp
Projector starts up but after 30 seconds a red fault light comes on NEC LT25 projector Red Fault light You might require a new bulb, or check the fans to make sure they're all still spinning.
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions