Questions & Answers for: maytag mtw5800tw

I just bought a maytag washer and upon installation I can't get the cotter pin out. if you can get to it, cut the head or loop of pin and pull one side at a time out with pliers or vicegrips

My Maytag Centennial washer jumps around during spin cycle. It moves 4-6 inches. Is this normal? I have checked that it is level, and I try to balance loads. Have to keep the loads a little smaller ...

My Grandma's Maytag Centennial Washing Machine is very loud. Is that normal? We were told it was, but it is really loud. Could be a worn bearing if its that bad, happens after about 10 yrs ...

...MAYTAG MTW5800TW TOP LOAD WASHER WILL NOT GO INTO DRAIN OR SPIN CYCLES, LEAVING A LOT OF WATER IN TUB. IT TRIES TO SHIFT FROM WASH TO NEXT CYCLE , HUMS THEN CUTS OUT. NEED HELP PLEASE JIM Hi, If you ...

Maytag centennial washer - power went out while washer was operating. When power was restored the washer does not cycle. I have to turn it manually through the cycles. Set the timer to any off ...

...Thank You for using FixYa. I will be helping you today.here is the link to get one http://www.maytag.com/owners-center/owners-center-homepage.content.html Thank You and please rate my answer if ...

knocking sound when spin cycle stops on my Maytag Centennial Washing Machine Check the springs that are located on the base of the drum assembly.

I have a Maytag Centennial MVWC6ESWW1 and need to know how to lift off the top cover to get to the lid switch? There are two hinges at the back, just remove two screws on top then push the top toward ...

maytag centennial washer belt broke How do I take my washer apart and replace the belt? It looks like the tub sank. There is no belt on that model you posted.

washer will not drain and go to done maytag centennial washer cloths still to wet to put in dryer its clogged empty your pockets before washing