Floor furnace pilot won't stay on. Pilot went out. While attempting to re-light it, it stayed on as long as the shaft was depressed (more than two minutes). When the depression was relaxed, the pilot ...
...floor furnace will not stay on My coleman floor furnace pilot light will stay on but the furnace itself will not kick on without physically holding in the magnetic gas valve. When you release the ...
Question about GWL11 Top Load Washer
...Floor Furnace need millivolt gas valve & pilot ki Looking for millivolt gas valve and a millivolt pilot assembly kit for a Coleman Gravity Floor furnace (natural gas). Unit is about 50 years old. ...
...floor furnace madel 570 edr You need a very kong wire and a kitchen match. Turn the knob on top to pilot and push down have your flame already down thru the pilot hole at the bottom of the inside of ...
...floor furnace Ward Model 570EDR. Most floor furnaces use the millivolt gas valve and need a pilot generator to operate correctly. These generators are bit more than a standard thermocouple. Ebay has ...
Question about (223600UP) Heater
model 3572 empire floor furnace pilot goes out when turn valve to on furnace will not light Clean pilot could be blocked or its the thermocouple needs replacing
...floor. It rained during the night. When we brought it in and lit the pilot, it would work for awhile, but ultimately goes out and has to be relit. Why Does My Gas Furnace Pilot Light Keep Going Out? ...
Question about (223600UP) Heater
...- Model #7956B856/D - the furnace turns on and stays on - the pilot light & furnace burner stay lit - air blows through the floor vents - NO HEAT! make sure fan is on auto and not on fan hi or ...
Question about (223600UP) Heater
...FLOOR FURNACE 65.000 BTU. GOT THE PILOT TO LIGHT WHEN TURN ON THERMASTAT TO TURN ON HEAT IT KNOCKS THE PILOT LIGHT OUT. HAVE CLEANED EVERY PART IN FURNACE. I would suspect the gas valve is
Question about (223600UP) Heater
...floor furnace pilot light will will not hold.pilot knob does not spring back when released. tested thermopile gen.is definitely ok.what now you dont trouble shoot a gas valve ===if valve not staying ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions