Model Number JE2160SF03 Serial Number: DL 901299M Our microwave oven's floor is peeling off horridly. We can see the metal beneath the white surface. We have lived here for two years, and it was a brand new appliance when it was installed. We would assume that this is not the way a two year old appliance should look. Please advise. Thank you!

Most likely if the metal screen in the door is intact. That screen and the metal cover on the back and sides surrounds the insides of the oven reflect the microwaves back into the oven. Just be careful about the peeling plastic inside.

3 things high heat low heat cencor or magnatron is bad

hi my name is mark, i found panasonics part website follow link http://www.pstc.panasonic.com/Epartr/PartsListChoice.asp?validate=1 if this helps please rate how i did. thanks for you question.

It should be sanded smooth and clean and dried thoroughly.

Then you can apply some high-temperature appliance paint, available from places like Wal-Mart, Lowe's or Builder's Square.

It's normally enamel on sheet metal, not porcelain.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

No, if the cavity metal of the oven is chipped or charred, it will have to be sanded smooth and clean and dried thoroughly.

Then you can apply some high-temperature appliance paint, available from places like Wal-Mart, Lowe's or Builder's Square.

Otherwise, you can have rust and arcing, which can be messy.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Sounds like rectifier gone.Needs testing by microwave engineer

Yes, if the cavity metal of the oven is chipped or charred, it will have to be sanded smooth and clean and dried thoroughly.

Then you can apply some high-temperature appliance paint, available from places like Wal-Mart, Lowe's or Builder's Square.

Otherwise, you can have rust and arcing.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Yes. If the cavity metal of the oven is chipped or charred, it will have to be sanded smooth and clean and dried thoroughly.

Otherwise, arcing and deterioration can occur.

Then you can apply some high-temperature appliance paint, available from places like Wal-Mart, Lowe's or Builder's Square.

We're happy to help and we appreciate your thoughtful rating of our answer.

William E. Miller, AS-EET
[email protected]
http://www.microwavedisplay.com

You need to thoroughly clean it, then sand it smooth to removew all the loose paint.

Once it's squeaky clean and dry, you can apply high-temperature appliance paint, which is available in brush-on or spray-on form at big box stores like Wal-Mart, home improvement centers like Lowe's and appliance parts stores.

Normally you can strip and sand the old paint, get it squeaky clean, and use appliance paint. Yes indeed it is a heat-resistant enamel. You can get it from appliance parts stores, Wal-Mart, or home centers, etc. BUT if it's under warranty I would call GE Customer Relations with your model and serial numbers. They're at 1-800-386-1215 (8-6 ET) and I would also suggest you ask them for a referral to a GE-authorized servide center in your area. Good luck. I appreciate your thoughtful rating of this answer.