After cleaning it and replacing numerous black cartridges, My epson stylus r300 printer won't print black ink. What should I do?

What Causes a Printer to Be Misaligned? ' Chron.com

smallbusiness.chron.com > ... > Setting Up a New Business Basics

A printer that has alignment problems will not print documents accurately. images and text ... Install new manufacturer's cartridges in the printer. If the cartridges ...

How to Replace & Align Canon Ink Cartridges ' Chron.com

smallbusiness.chron.com > ... > Computers

Misaligned cartridges cause poor overall print quality by producing print lines slightly... Remove the new cartridge from its packaging and remove the colored ...
PDF]Stylus Photo R300 / R300M - Product Information ... - Epsonhttps://files.support.epson.com/pdf/r300__/r300__pg.pdfEpsonEPSON Stylus Photo R300 Series - 1. Printer Parts ... asterisk (*). The printer also works with plain paper. Cartridge. Part number. Black. T048120 ... Letter. SCR1001. PremierArt Matte. Scrapbook Photo Paper for Epson. Letter ..... Unwrap the new inkcartridge. .... misaligned, align the print head (see page 11). Related ...[PDF]Epson Stylus NX430 - Quick Guidehttps://files.support.epson.com/pdf/nx430_/nx430_qr.pdfEpsonAfter you set up your Epson Stylus® NX430 (see the Start Here sheet), turn to this Quick. Guide and ..... Load letter- or A4-size paper in the sheet feeder. 2. Press ... Use the following list when you order or purchase new ink cartridges: Note: We ..

Silly question: Did you remove the plastic tape from the bottom of the cartridges when you installed them?

Make sure the printer is on and not printing. Have a new cartridge handy, as this installation should be done in one session.

Note if the "cartridge is low" or the "cartridge is empty" light is activated on the printer and follow the specific instructions carefully in the document below for each situation.

See "Removing and Installing Ink Cartridges" in the following document:

Epson Stylus Photo R300 - Removing and Installing Cartridges

YUP>>>
Epson,. has it rigged, that you must have ink in all the cartridges.............! Doesnt make a difference, if you are printing black and white ONLY.

You have to make sure that you always have ink in all of the Cartridges.
Good Luck......

If you find this information helpful, pls rate me. TXS

1) Unplug the power cord, wait 30 seconds, then plug back in.

2)Did you follow the directions exactly when replacing the cartridge? Did you peel off the protective film?

I know there are some cleaning cartridges with a chemical thinner that could clean any ink residual that could interfere with proper function of the printing head.
If this doesn't work you probably have to replace the head.
Check also the flat cable that follows the printing head during movement.
Fabio

there is a strip to remover over the bottom conection. take that off and you will be find.

reset your printer using r300 ssc compatible software..try to googlinf

i would suggest cleaning the heads.

you may need to run a clean on ur nozzles and check if you are low on ink.