Misfeed and PDF failure

What else do you think it could be but a corrupt file? Two programs say the file is corrupt....the file is corrupt. Have them resend the file if you can, otherwise it's lost.

DEAR SIR WHERE YOU REMOVE THE PAPER IN THE MACHINE THAT SECTION THERE IS PAPER PATH SENSOR ,THAT SENSOR POSITION IS ABNORMAL PLEASE CHECK THE SENSOR OF THAT SECTION WHERE YOU REMOVED THE PAPER


Hope this may help;

Regards,
VOTIT

If you have the same operating system, same internet explorer version (from any page click the help button on top of page and select "about internet explorer" to see), and same version of Adobe reader then you might consider running a virus scan. I.E is a target for malware.

The MISFEED Indicator blinks when a MISFEED has occurred. Remove the misfed paper referring to the the description of MISFEED REMOVAL beginning on page 65 of the pdf Manual at:

http://files.sharpusa.com/Downloads/ForHome/HomeOffice/PrintersFaxMachines/Manuals/cop_man_AL2030_AL2040CS.pdf

When the MISFEED Indicator is blinking you should look closer at the paper feed area (see page 66 of the PDF). You may need to remove the paper tray to find any remnants of paper. If after closing the side cover the light does not stop blinking you will need to follow through as per the illustrated instructions.

Remember after removing jammed paper, you need to press the clear key to clear the MISFEED error.

If after doing all this the error signal has not cleared, power down the printer; unplug from the power supply; let rest 5 - 10 minutes; plug back i to power supply; turn printer on and see if this resolves issue.

Trust this is helpful. Please vote. :)

use pagemaker for scan your document.

Create a new windows user account .Try to scan the document in the new admin user account.

Have a look in the user's manual:

http://www.sharpusa.com/files/cop_man_soho_AL1642CS.pdf

Try scanning a "photo" to file and using the advanced scan options to set a lower DPI. Then from the Library view you can convert that 'photo' (of a document) to PDF.

Steve

When you close the doors does the message disappear? If so then the paper pickup roller is worn. Open the cassette remove all paper apart from one sheet. Spray a alcohol based cleaned on the leading edge of the paper. Try and do a copy this will issue a jam and also clean the pickup roller. repeat a few times then clean out the cassette and dry off place new paper in the cassette and try. Also there maybe a piece of paper behind the cassette. Remove cassette and reach in and remove paper lodged at back.

Thanks Jason

Don't worry about the clean roller message. It is just a reminder much like your scheduled maintenance light that appears in your car.

Start Failure can occur for a number of reasons. When you get a start failure message close your scanning software and reopen it. Sometimes your connection may degrade if left idle. If that doesn't work shut down the scanner and pc. Turn on the scanner and wait until it is fully initialized before turning on the PC. These steps have resolved that problem for me. Lacking a manual, I just try things. Good Luck