When I start a program, It displays

It is possible the motor start capacitor has failed. Unless you know how to test it, call a service person.

To exit the DEMO/TEST mode, press and hold down the "On/
OFF" and "Start/Cancel" buttons until "d off" is displayed

Hold In on/off and start buttons together for 10 secs.

no its the programer at fult

there is no F65, perhaps it's F05 which means it will not empty water (not oumping out). Should av gone to specsavers !

turn on while pressing the on and start buttons at the same time until 'dOFF' appears.

it's on test mode for the factory. this comes on if you hold the on and start buttons together. can be reset by turning on while holding both on until dOFF appears.

its in factory test mode, this can be set by pressing the on and start buttons together. to reset, turn on while pressing the on and start together until dOFF appears

Hi i have a hotpoint wd 860 washer dryer the display is showing f 08 heater relay cannot be activated.can you please tell me how i can fix this problem myself.Thank You

hi, i have the same machine..i have a feeling it does this annually to make you call an engineer. to reset it do this; hold the 'start' button until all lights display, then press 'start' again. hold the 'start' and 'on/off' button together until it reads d-end or d-off. it doesnt always work 1st time so keep trying, good luck x