What does E00 mean on a vibro plate - Office Equipment & Supplies

E00 usually requires a technician to reset, although you may manually do it by pressing and hold the start button for five seconds the "feature" should disable. E21 is blocked filter or excess of fabric in the filter over time. Turn the appliance off by the main supply, access the filter located on the bottom kick plate. Remove the filter and clean in hot soapy water, check the propeller for fabric debris. Run a hot wash without any clothing 70C or above with 1/4 cup white vinegar, you should do a maintenance wash at least every month and clean and remove the powder draw or detergent draw and inside every 2 weeks, clean the rubber door seal remove coins which are common and build up of debris

try this link http://howtomendit.com/answers.php?id=502630
Also try this https://www.youtube.com/watch?v=PvJlqOjG6Uc

Brand and model? What do you mean by number one port?

Hi friend, thank you for your inquiry!

On an Electrolux washer the error code "E00" stands for No code stored. This could be a miscommunication I would recommend you perform a reset on your washer. You can do this by flipping the household breaker for roughly ten minutes. If resetting the power does not correct the issue, could you please inform me of the new error code or if your washer continues to display "E00". I look forward to assisting you. -Matt

I recommend using a lockable enclosure.
e.g. NBP141004-E00 ( 14x10x4 Inch Universal 120 240 VAC Weatherproof Enclosure NBP141004 E00 ).

Hi William, thank you for your post!

If you are getting error code E00, it usually indicates that your washer is experiencing a generic error. One of the best ways to determine if this is a false error code is to reset the power to the appliance by either unplugging it or flipping off the breaker for about 30 seconds. If the error code

E00 Means the red magnetic key (the one on the string) is not inserted.. If it is then the magnetic switch may be faulty.


E01 Is an electrical fault - the wire that runs inside the frame is probably crushed while assembling

E02 Means the motor is not running - either burnt out, stuck or the optic device is not functioning correctly.

This are what I found out by trial and error - hope its useful to someone - I'm looking for a copy of the manual for this thread-mill if anyone could send me a scan or photos of the pages - thanks very much.

I tried to locate the manual with google, and had success. You could ask like here. The services are not for free, but most times worthy - saved my live more than once.

1. comment on annule aver lepanneau de commande