THE R300 BELLVILLE OFF RAMP FROM THE N2 DOES IT STILL CLOSE AT 7

:It is possible that there could be an issue with the wiring or a malfunctioning motor on the ramp. I suggest having a qualified technician take a look at your vehicle to check the wiring and motor for any problems. The technician should also be able to help you determine the cause of the issue and advise you on how to proceed.

....the wear marks normally show you how it was assembled, if they are new, shouldn't really matter

Do a prime factorization of the two numbers. Use condensed (power) notation for each prime factor.
Example
N1=(2^5)*(3^4)*(7^2)(11^3)
N2=(2^4)*(5^6)*(11)
2 is a factor in N1 and N2, the smallest power of 2 is 4, thus 2^4 is common to N1, and N1. You could write 2^5=2*2^4
11 is a factor in N1, and N2, the smallest exponent of 11 is 1, thus 11 is a common factor of N1 and N2.
Highest common factor of N1 and N2 is (2^4)*11

The driver is included with Windows 7. Go to http://www.epson.com/cgi-bin/Store/support/supDetail.jsp?oid=26322&BV_UseBVCookie=yes&infoType=Downloads&platform=OSF_W_7-64 and click the "More Info" link.

Ann has 80 pesos and Rosa Has 140 pesos. Calculated by taking the 4 to 7 ratio and keep multiplying until you reach the 60 pesos difference which is 4X20=80 and 7X20=140. 140 minus 80 = 60.

Windows 7 drivers here http://www.epson.co.uk/Printers-and-All-In-Ones/Inkjet/Epson-Stylus-Photo-R300/Drivers-Support?_DARGS=/jsps/support/modules/mainContent.jsp#

There doesn't seem to be any specific Windows 7 drivers, but the Windows 7 Compatibility Center, states that the drivers found here is compatible. Make sure you choose the most recent driver and that it is the correct one in regards to 32bit or 64bit.

try to download from this, http://www.epson.com/cgi-bin/Store/support/supDetail.jsp?BV_UseBVCookie=yes&oid=26322&prodoid=37368458&infoType=Downloads&platform=All

Epson has no windows 7 driver for this printer. Only printing software which doesn't help at all.

Hi Chillyslade,

Try this..

Close the CD/DVD guide, then press the maintenance button.
If the CD/DVD tray is inserted, remove the CD/DVD tray, then close the CD/DVD guide

Hope this works, kindly let me know by providing your valuable rating.

Thanks,
Robosoft.