Electrolux dryer My dryer is stuck on paused and won't restart.nor spin.

FIXED - GFD85ESPN0RS GE Electric dryer flashing panel

Appliance Blog https://www.applianceblog.com > ... > GE/Hotpoint
Nov 17, 2020 - Power went out for a while, and when it came back on, panel flashing...all LED's. if I hit "start/pause", then the sequence starts, 0-8. Not ...

Start - Pause LED flashes on tumble dryer - electrolux.ie

electrolux.ie https://www.electrolux.ie > support > laundry > dryers
Jul 26, 2022 - The Start/Pause LED will flash for a variety of reasons. ... If your machine isn't starting, try the following: 1. It is possible that your tumble ...

E51 - means motor power triac short circuited.
Current leakage from motor or from wiring, main PCB faulty.

Dado

take out the plug and change the capistor ..make a note of the wires and take picture where they go

Good Morning Jill,

So I see that you were drying bath mats and the dryer got stuck in a "Pause" mode and even if you cancel and restart it shows "Pause" on the display. I would suggest resetting the dryer. What you will need to do is either unplug it or you can shut the power off at the circuit breaker. When you do this you will need to leave it off for at least 2-3 minutes. Cut the power back on, start any cycle. If you are still having trouble not being able to start the dryer and "Pause" showing, I suggest you either contact the manufacturer or your local authorized technician. I hope this is helpful.

-Best Regards-
WP

Hello david_whi764 - Try reprogramming the dryer by unplugging it or flipping the household circuit breaker off. Wait approximately ten minutes, restart unit, and select a normal cycle. Does it continue to Pause? If so, then the unit may be experiencing a communication error with the control board or wiring failure. I personally recommend contacting a professional to move forward accurately and to assist with the repair(s).

if it makes a humming noise for a short peiod then stops and after a while it does it again the drum maybe stuck and making the motror go off on overload try turning the drum by hand and see how it spins

Isyour washing machine displaying an error code? If so, try using the owner's manual to decipher the code and you may beable to easily diagnose the problem. The problem could be as simple as the doorbeing slightly ajar, the machine is in pause mode, or the spin selector isstuck. Checkthe handy chart in the article Washingmachine won't advance to washer spin cycle for more possible reasons why your washingmachine won't advance to washer spin cycle-and some tricks for getting itworking again.

My first instinct is to slam the door.

Hi I exactly have the same problem.. seems to be a common issue with this Electrolux series.. Thought that Electrolux was serious brand but obviously quality is leaving our world.. did you fix the problem and how..?

There is a 'tech sheet' in the back pf the dryer. Unplug machine, Remove the access panel on the back to get to it. Reach in and it should be there. It will tell you how to do a button check. You have to enter a test mode through the buttons.
The E 61 is a stuck button.


Enter function test mode and perform key
stuck closed (active). (button) test to determine which button is at
fault. Carefully free the and perform the test
again. If button is free but the key struck code
still exists, replace electronic control.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c