PT-2400 HOW DO YOU VERTICAL PRINT - Brother P-Touch 2400 Thermal Label Printer

You need to go to printer setting and go to print type. now you will able to see your paper printing type. you need to click on that and select A4 paper size.

Hope this helps... open the link: http://www.ptouchdirect.com/ptouch/umpt1000.html

Goodluck!

top left click file then page setup then change it portrait to landscape or vice versa

left top corner file page setup alter it from portrait to landscape

I found 2 helpful manuals from brother that you may want to checkout. they explain exactly how to install the cartridge:
http://www.ptouchdirect.com/ptouch/manual/PT1000.pdf
http://www.ptouchdirect.com/ptouch/manual/PT85.pdf

hi,
firs of all remove from the mains. pull out the rubber bed over the platter. check whether there is any lock washer in the center shaft. if have remove it. if not its ok. now pull the platter towards upside by putting the fingers in to the holes provided on the platter. remember pull using ur two hands in opposite direction.
ok

Hi,
IC451 (Vertical Output) LA78045 part number is C1AA00000521
Available in Part Store.

Above info are taken from related service manual and an image of s.manual is given below...

Try F+3, select style and scroll through the selections until you see vertical. Select it and you're on your way. If you don't have the instru, go here:
http://www.brother-usa.com/Manuals/Default.aspx?WT.cg_n=Support&WT.cg_s=Manuals, and choose the English manual.

Start the Konica Minolta Status application and check the error, you should get more info there.

Reset your Toners and Imaging units for Bizhub and CF series.
http://www.chipreset.eu

There are two vertical fonts - small and normal. To put the labeler into vertical mode, hold down the [Code] key and tap the [J] key.
When it asks " 1-9 ", let go of the [Code] key.
Press the [8] key if you want small vertical type, OR the [9] key if you want normal size vertical type. Then you have to hit the [ <--' ] enter key.
Now you are stuck in Vertical mode ! :-O

To get back to normal, hold down the [Code] key and tap the [J] key, Let go of the [Code] key.
Then tap the [3] key and the enter [<--'] key. You are back to horizontal labelling.
:-) phew!