FREEZY AND DELAY REACTION

flat/ faulty battery

NEW TV's HAVE TO PROCESS INPUT FROM CONSOLES
and it takes time
i am MLG and if you want better reaction speed use an older television which generally respond instantly

Try TLD . com

Replace the relay first if this doesn't work you will need to reolace the switch gear. Although the relay is the leading suspect. Hope this gets you flashing properly.

It sounds to me like there is a noteable delay due to a combination of things: your Bluetooth wireless controler (primary reason), and the cable connection from your PS3 to your TV. Now, to determine what the problem is specifically, you'll need to check a few things:

1. Make sure your PS3 is updated to the latest software

2. Check to make sure your cable connections from your PS3 to your TV are firmly in place. I personally have noticed that I got delayed reactions when my HDMI cable was not firmly secured to my HD TV. Weird, but as soon as I unplugged and re-plugged in the cable at both the TV end and the PS3 end, it cleared things up for me. If that does NOT work (btw, this can also be the case if you use a composite or component set up too).

3. Check to make sure that your PS3 controller is fully charged. Controllers that are partially charged occasionally do demonstrate really weird results, like the delay you're talking about. So, make sure that your PS3 controller is fully charged.

4. If the controller is fully charged AND your PS3 to TV cable is plugged in properly, then try to plug the USB cable to connect your PS3 controller to your PS3. Sometimes, for reasons I don't know about yet, this could solve the delay problem.

prior to adding the freon did you have system evacuated with a vacuum pump???? If not there is air in your system causing the delay reaction for compressor to kick in

stevec795

Do you have fresh batteries in the remote? Drained batteries can cause the delay problem. If you do have fresh batteries, then you will need to readdress the remote to the receiver. I have provided instructions on readdressing the remote. I hope this helps.


Remote: All Other Remotes

1. Go to System Info screen
2. Hold down the SAT button until all mode lights light up.
3. Enter a number between 1 and 15 using the numeric keypad on the remote.
4. Press the pound (#) button
5. Once the SAT button blinks three times, press record. Note: If successful the number selected in step 3 will appear in the System Info screen under Remote Address.

Ray Calo
DISH Network

Sounds like your cold start valve has an issue go to www.benzworld.org or peachparts.com for some good info on it.

I would suspect this is caused by your Internet conection speed. Try going wired first, dissable any bacground downloads manually, make sore no other equipment is using internet at the time you're gaming

Have Fun!

Here is what hunter technical support says about this.

"The light fixtures are manufactured with a limiter that prevents a higher than recommended wattage bulb from working. The limiter causes the slight delay even when the correct bulbs are is in use."