What size is Maytag LAT8506AAE - Maytag Washing Machines

I'm sorry but I'm unable to find the cubic feet size of Maytag dryer model SDG515DAWW. However, you may be able to find this information on the Maytag website, in the product manual, or by contacting Maytag customer service. Additionally, you can measure the interior dimensions of the dryer to estimate the cubic footage. The interior width, depth, and height measurements, when multiplied together, will give you an estimate of the cubic footage.

google maytag dwu7400aax dimensions for your answer less than 3 seconds.


This is just a standard size dishwasher model. Dishwashers in general are going to be standard size unless you get a portable dishwasher or a 30 inch wide dishwasher. There are very few of these models. Your size dishwasher is just 24" wide 24" deep and 34 1/2 inches tall but the height can be adjusted somewhat

Approximately 3.2 cu ft

normal tap size is 1/2 inch same as garden hose fittings for garden taps

This model holds 45 pints, or 22.5 quarts.

Ohm out the blue/ blk terminals on the sw (remove wire harnes first and notate wire color connection) with an ohmmeter-- Reading should be zero (closed lid position)
Then ohm the ylw and white sw terminals-- reading should be 0 as well.
If I am not mistaken this sw has a plunger that sticks out, if hte unit goes off balance this could push the plunger in. to reset- pull the plunger out

Lou
AFFORDABLE APPLIANCE REPAIR
(949) 855-0788

Hi, I would check the lid switch first. Remove the two screws that hold the control panel to the cabinet and let it rest on the hinges. Locate the lid switch connection and either test it for continuity or use an insolates wire and jump the switch by inserting the wire into the gray and brown wires. Turn the washer on and see if it works.
Please let me know if this helps or if I can assist you further.

Thanks
Vic

Try this for re-setting the balancing mechanism:
With the washer empty, tip tip it forward so that it is just sitting on the front feet. Hold it there for a few seconds, then gently lower the back down. (Often there is a mechanism in the back feet that automatically levels it for you--if this doesn't work, check that the back feet are not damaged.)

I have the same problem with my Maytag LAT8506AAE machine. Do I need to fill up any oil after the seal replacement?

lower gear box coupling has sheared