When I plugged in my pfex01312.0 it would not calibrate

Pull the plug on the ref. When you plug it back in it should re-cal.

For those having the "Executes calibration. Pull out the film and place the Film Adapter Unit at Frame 1." issue and cannot calibrate the scanner for NEGATIVE FILM, it took me ages to figure out how to solve it.
Solution: calibrate the frame, WITHOUT any film, adapter plug and placed in frame 1, and proceed to do the calibration WITH THE SCANNER COVER OPEN.
Before I tried everyhing, install new drivers for Windows 8.1, MP Navigator, and nothing happen. Now it works like the first day. Hope it helps! it certainly helped me.

have you calibrated those plugs well ? .050 inch its the gap calibration for that type.

The factory settings come with this parts number:
- Champion Double platinum RE7PYP6
- Champion Iridium Plug 9901

Just replace it, without GAP calibrations.

Hope helps.

I have a NordicTrack C2155. Incline not working. There is a schematic inside. There are red, white, & black wires from the circuit board to the incline motor. Unplug the treadmill and have a licensed electrician construct a flying lead cord with a male spade on neutral and female spade plug on hot. Connect neutral to white and hot to where either red or black were connected. Plug in to see if the motor runs. Careful to remove power when the incline reaches its limit and reverse direction. If the motor runs in both directions, the motor is good. Follow the black two conductor wire to the circuit board and unplug from board. Check continuity across this switch. Run motor and this should toggle off and on. If all this checks out then the problem must be with the circuit board. On my treadmill, the schematic says that +5v should supply the sensor, but I only get +3.3v, which is TTL level. The drive motor sensor supply is +5v. The incline motor doesn't even show a sign of trying to run. Either the output transistor is burnt out or the low voltage caused an error so that it does not try to run the motor. Either way, I'm quite certain that a new controller board will remedy the problem.

hi there, i just want to know if the problem is solved by now, cause i need the solution too cause i have the same problem with my alcatel ot 880

Spark plugs do not need calibration!! Although it may need gapping which requires a gapping tool such as a filler guage!! Check your local autozone for this tool and gapping specs for this vehicle!!

go to auto parts get you a plug gauge,they will help you gap your plugs to spec,thank you

Please ensure that you have turned on the Accoustimass module, this can cause communication errors when calibrating. Also check that all connections are correctly plugged in as if one is not quite sat right this may give the error, just try unplugging them and plug them back in.

I had the same symptom on a SONY DAV-DX375. The problem was I didn't have the mic plugged in far enough. The receptacle is very tight even though it is very tiny. Make sure to push plug in until the plastic part is against the front panel. It sounds obvious, but I was surprised how much force it took to seat the plug.