I have the gwl 207 flqk side by side, no water feeding ice machine but is feeding the water dispensor

It's possible it was installed improperly.... try removing it and re-installing. May have a filter that is clogged... only way to determine this is to replace it with another new one.

You have 2 problems .
1 . the water valve is not letting enough water in . Pt # WR57X10032 . This is located on the back of the refrig , where the wall water line connects to , on the refrig .
2 . The dispensor flap door , is not closing completely , to seal off the warm outside air , thereby , causing frost on the inside dispensor area , and , on the bottom of the ice dispensor bucket . The usual cause , is the door flap solenoid , pt # WR62X10055 . The plunger , which comes with the solenoid , usually rusts , causing the flap not to close completely .

Yes, you can repair this yourself to save yourself a lot of $$$$$$$$. This is your dispensor switch that has gone out and we have this part in our inventory.

Just contact us at:

http://www.fixya.com/repair/d499389-accurate_appliance_repair_service and we will get this out to you asap.

We hope to get your ice and water in your dispensor flowing proplery again real soon.
Thanks, Ella

You have a bad dispensor flap solenoid . Frost due to flap not closing completely and ice will catch in the shoot .

you might try asking the mfg. site about this problem
https://jennair.com/appliances/details/JS42SSDUDE

did a search and nothing else come up. give them a try.

hmm, wonder if the flap is broken inside where the water comes out or the control board is not working properly

hi thanks for the question i would check the water valve at the back to see if it is ok if you have a volt meter you can check thanks the appliance doc

The water valve appears to be the problem. The water valve ,located on rear of ref. at bottom has two (2) sides to it. One side feeds the water to the water dispensor and the other side feeds the ice maker..

sounds like icemaker not turned on

Womers, make sure there is not a lock-out on the dispensor panel. If there is, hold it in for 5 seconds and see if the dispensors come alive. Because both water and ice are not working, I would think you have a dispenser board issue. Catriver..post back.