Won't start up ,green light come's on

Remove battery and clean the posts of corosion , also the contacts from green gue , sand the contacts , re install . Clean main contact to starter also .

check breakers in breaker panel,I need more info.is it blowing air inside

You can try doing this first, plug it in to your outlet and switch it on. If it will not start, try to move the wire near the plug to see if the problem is a lose wire in that area. If it responds in moving the wire you have to replace the plug of your vacuum. Message me if you need further assistance. Thanks..

check your battery sometimes it will have enough for lights put not kick in starter then check alternator take to auto zone when running the will test free

Hi Chris!
As you described, I didn't see anything would cause the problem. Just suggest that you could give it a clean. Sometime just because you use it for a while(finish a toner cartridge), it get dirty. Unplug the power, and gentl take out the cartridge, paper tray then clean the roll and surround with wet clean paper. Give it a try and see what happen. Please make sure that you do it gentle when put back things.
Hope this will help. Thanks for reading.

Hi Good day!! did you try to print other documents? if yes try to restart your print spooler Click Start- Setting- Control panel- administrative tools- services now you should be on services box find the "Print spooler" click Print spooler and then restart it by click stop and then start
reply to me for further assistant if my solution did not work thanks

Thank you for using FixYa

Try replacin a new display card. If it is fine working.ok
If not try fixing for cold solder in the video section.
I suggest video section according your report the light green LED lighted that shows the power section is doing fine.

The printer is in line mode. Do the following to take it out of line mode:
Turn printer power off.
Hold the feed button while turning printer power on.
When the light starts flashing, release the feed button.
When the light starts flashing again, press and hold the feed button.
When the light turns steady amber, release the feed button.
When the light turns steady green, the mode is changed.
Verify the mode by printing and inspecting a status report.

This requires good timing and may take several tries. You'll know it worked if no labels are reeled out after you're done.

weak power supply