Lexmark All-in-One Printer with PictBridge "removing feed roller shaft" Questions

feed roller ( small black one in contact with paper) was not rotating, Also when the back cover is removed the roller also did not rotate. I took apart the printer and found that a white gear with the

...feed roller and pickup roller) Procedure 1. Remove the paper cassette. 2. While pushing the lock and then slide the paper feed roller pin. 3. While pressing the lever and then remove the paper feed ...

...feed roller/shaft/clutch and the ADF Separation Pad/Roller. Should be 002N02001 for the Feed Roller Assembly and 22N1487 for the Separation Pad About $50 total for both parts Good Luck and Thank You ...

...feed roller,this becomes "glazed" with the additives in modern papers. To gain access remove the power supply remove 1 screw holding its retainer in position and remove it. Remove the white gear on ...

feeding through to print. Remove the paper cassette and the toner. Turn the printer upside down and look at the feed roller. It should NOT spin freely, drive tabs may be broken off of the roller shaft

...feed roller replacement - how to... There are 2 tires on one shaft and a spring. Releasing the white clip on right hand side (like HP) does nothing useful. I expect I'm going to have to take off the ...

...feed shaft is missing. This roller engages the metal 'yoke' on the LHS when the printer lid closes and provides a suitable pressure for the paper to contact the thermal head. They break into 2 pieces ...

...feed is not working. I've tried cleaning the rollers and checking for a paper jam, but the rollers were already clean and there is no paper jammed. What can I do to fix this? Check the gear on the ...

...removing the paper tray in question to look inside the printer. b.Locate the rubber roller with a purple, plastic hub (paper feed roller). c.Locate the paper pickup assembly that is directly behind ...

feed switch switch seems loose on the cassette and not recognizing paper being loaded after i changed the pickup roller When you changed the roller you knocked the sensor out of place. Normally when ...