Question about HP PhotoSmart Office Equipment & Supplies
...error messages, power looping at switch on, paper getting jammed, cracking and grinding because the print head motor was trying to drive the head through the side of the machine and all caused by a ...
Question about HP PhotoSmart Office Equipment & Supplies
...error. When the printer was opened the print head moved from park to the middle of printer and back. What next?? When powered up press the ink button. This should cause the print head to move to the ...
...print. Displays "Error Oxc 19a0035 Kinldy remove printer, uninstall and then reinstall the prrinter software, then connect the printer and test. If there is mating of the printer and shows a errror, ...
...Print Cartridges , then follow the on-screen instructions. Up to three levels of cleaning are available. Discard or recycle the page that prints. Clean the contacts NOTE: The printer will only ...
...head technician" who is due to ring me tomorrow. I will let you know what my resolution is. Basically, my problem is that my network (I use a netgear router) and have one wired (XP Pro) and two ...
...error appears on panel, go to the system open internet explorer type IP address enter you can view the entire printer over view.. check which print head showing faulty, ask to replace the head ...
Question about HP PhotoSmart Office Equipment & Supplies
Print head Error indicator. In this case, the print head of the printer is faulty so that the printer cannot detect the print head. About the print out, please check if there is enough ink in ink tank
...error is either a print head temp sensor error or faulty EEPROM data from the print head. You need to re-set the print head. If that fails then a new print head is required. ...
not properly installed (Print head temperature sensor error [1403] / Faulty EEPROM data of the print head [1405]). If you wish to get more details about this; visit the site linked here; after an hour
.../ Temperature Sensor that is causing the U052 Error. Error U052 = Please check that print head contact pins of the carriage are not bent. Or else you may need to replace - Print head - Carriage
56 questions posted
Usually answered in minutes!
1,869 Questions
1,438 Questions
900 Questions
484 Questions
508 Questions