Question about Maytag Neptune Washing Machines
...Lid takes long to lock once I hit lid locks or slam lids down it locks Once I slam the lid ! down ! then it locks and starts to wash it should start easily ,the lid switch may need to be ...
Question about Maytag Neptune Washing Machines
...RUNS IN TUB, BUT WHEN YOU PUT LID DOWN WON'T START AGITATING UNTIL YOU SLAM THE LID NUMEROUS TIMES there is a safty switch in the reciever part of the lid assembly it eather is loose or broken
...lid down to get washer to start The switch associated with the lid must be out of place or something because you have to really slam the lid to get the washer to start. Is there a way to adjust the ...
Question about Maytag Washing Machines
...down the top door to the washer, it starts. Any ideas of what is going on with the washer? At this time we can't afford a new washer. Any suggestions would be appreciated. Thanks, Diane I think it is ...
...lid is down. no need to slam the lid.. There is no pin to push the activator switch.. they are controlled with a magnet... The micro switch is held in with a little plastic clip. Over time the clip ...
...lid is down. You have to lift it and shut or slam down. Now it wont start washing, and of course I have a load in there. I keep lifting, shutting, slamming. Any suggestions? The same thing happened ...
get it to wash after it fills with water. The lid switch need replacing or adjusted. When the lid is down something pushes the switch down. It could be back at the hinge or a slot elsewhere in the top
slammed the lid down. I also can not find my manual which isnt helping the matter. RE I have looked on Kenmores web site and the manual ony shows how to operate and install the washer, not how to take
Question about Whirlpool Washing Machines
...in ten without the slamming. on the inside of the lid there is a lid switch hole that a plastic tab goes down through the switch could be bad or the screws holding the switch in could be lose or ...
Question about Whirlpool Washing Machines
...and harder these days. The lid switch need to be replaced. You might try to lengthen the rod that pushes it down. You might try trimming lid bumpers with a razor blade to make the rod go down
1,827 questions posted
Usually answered in minutes!
2,979 Questions
358 Questions
175 Questions
151 Questions