The fabric softener and bleach do not dispense during a cycle. They remain full after the load is...
(More)
The fabric softener and bleach do not dispense during a cycle. They remain full after the load is complete.
Have a front loading Neptune, not all the water is being spun out at the end of the cycle. The...
(More)
Have a front loading Neptune, not all the water is being spun out at the end of the cycle. The heavier the load the more water that is in the drum. When clothes washing it sounds like it is dragging. Don't know if it would be a motor or the pump.......Help...Larry
Maytag washer will not lock and start I read some reviews about the top loading Maytag washer and...
(More)
Maytag washer will not lock and start I read some reviews about the top loading Maytag washer and several said they had to replace the circuit board and it still did not work. The insturctions say there may be a loose plug. But the more indepth explanation said that its the Continuity between p.6 pin 1 and p.8 pin 1 on the circuit control board. I ordered a new circuit board and can return it in 30 days if not needed. However this Maytag is supposed to be able to reset itself. Any suggestions.
My clothes are stuck in my neptune. It won't drain and the door will not unlock. How can I restart...
(More)
My clothes are stuck in my neptune. It won't drain and the door will not unlock. How can I restart it?
my maytag washing machine stop working totally mid cycle. I'm not getting anything when I turn and...
(More)
my maytag washing machine stop working totally mid cycle. I'm not getting anything when I turn and pull out the know
My Neptune TL is not completely draining. I've got the tub out but am having trouble getting the big...
(More)
My Neptune TL is not completely draining. I've got the tub out but am having trouble getting the big bolt off the bottom to open up the tub. I've checked the pump and lines and they are clear. I can still here water in the tub so I would like to take it apart to inspect
I have the Maytag Neptune MAH8700 series. I keep receiving the E3 error. It seems to happen just...
(More)
I have the Maytag Neptune MAH8700 series. I keep receiving the E3 error. It seems to happen just before the spin cycle. I have checked the wiring harness connectors for loose connections and that does not seem to be the problem. I have been told that I may need to reset the memory. Is this possible on this machine?