Maytag Neptune MAH5500B Front Load Washer "door lock switch access" Questions

door lock switch (not the one that turns your "door locked" light on) which allows your spin cycle to engage is probably not engaging properly. This is usually caused by the failure of the motor which

...they are tight if of check connections to the central control unit if ok too,replace door lock by removing outer door boot spring at door lock and remove off the front to access the door lock ...

door lock the door will not lock, i took the front off and and reset the switch, could not tell if it was popped pushed it a couple times re atached the door and no difference, any ideas? The MAH5500B

...door and the lock light does not come on and the water is not running in machine From what you've described, the problem may be a defective "door safety switch". The purpose of the lid/door switch is ...

...lock the door need door latch switch part # 22003269 Bet if I did enough homework, obviously unplugged the unit, I could fix the unit myself right? yea, not that hard th change the latch, you just ...

...door lock indicator light "on") after cycle has completed. I have tried restarting the cycle and allowing it to complete as well as unplugging the machine. Maytag support told me to remove the ...

door lock doesn't go on. i unplug and wait for 15-20 minutes and do the same thing. and nothing happens? WASHER WILL NOT START: Power If your washing machine won't start, begin by looking at the power

...Door Lock Motor and Switch Assembly If the washer won't drain the door lock assembly should be checked. The door lock can fail either mechanically or electrically. Test any switches on the door ...

door switch. These washers have a common problem associated with this code. The door isn't completely waterproof and allows water to get into the area where the lid switch is, corroding the electrical

...door latch assembly has this green plastic tube, wire, something like that that comes out of the switch but I have know idea where it goes can you help me? had to remove lid to fix front rubber seal ...