Question about Washing Machines
...shift actuator but this washer design has had many problems. I would first unplug/replug all the wiring connectors. Tilt machine back for access to connectors for motor, capacitor, shift actuator and ...
Question about Amana Washing Machines
...shift actuator Amana washer worked 3 loads then quit again. not agitating right and not spinning. why would the new shifter stop working again? fills and drains OK. The replacement shift actuator may ...
Question about Whirlpool Washing Machines
...not spin then odds are the actuator is not shifting it from wash to spin or the main board is sending the signal to the actuator to tell it to shift. My top load Whirlpool washer won spin how do fix ...
Question about Maytag Washing Machines
...Shift Actuator cause this? Belt slides down, actually wore a grove through the plastic cover. I replaced the clutch assembly/belt/cover & worked for a while. Stopped working again after 3 weeks. Belt ...
Question about Kenmore Washing Machines
...and nothing else happens. Kenmore top loading high efficiency low water washer, model 2800*010, 2801*010 Most likely mode shift actuator is bad, but be sure drain Pump is working and ...
Question about Whirlpool Washing Machines
I replaced the lid lock and the shift actuator; now my washer will not fill Check the water supply for both hot and cold make sure they are open
shift actuator with a multimeter i tried to run a diagnostic test and the wash cycle and drain cycle worked well but the spin cycle would not work at all,just go a loud noise, and the lid lock flashed
Question about Kenmore Washing Machines
with the actuator, but it's hard to say for sure without further testing. The actuator controls the shifting of the transmission from agitate to spin, so if it's not working properly, it could prevent
Question about Maytag Washing Machines
...replaced. If so, most problems I have found from that model comes from shift actuator under machine that shifts transmission from agitate to spin. Also be sure drain Pump is working and pumping
shift actuator. It is a small round plastic motor that allows the washer to shift from agitate to spin. Really easy to change out. Find your service manual which is located in a plastic bag behind the
130 questions posted
Usually answered in minutes!
9,125 Questions
2,624 Questions
2,038 Questions
1,413 Questions
1,373 Questions