Heat lamp consecutive on error - Broken main fuser connection *Heat lamp consecutive on error - Check HR thermistors with SP1-106 001 (ctr) and 002 (ends) *Heat lamp consecutive on error - Heat roller
Question about Toshiba Office Equipment & Supplies
heat temperature, the printer gets to ready mode.-------- In your copier this fuser assembly is not heating to required level, so its just showing this " Wait Warming Up" message on display.----------
replace heater lamp toshiba 281c how do i replace the heater lamp in my toshiba 281c open side cover remove fuser kit and replace heat roll OR heat lamp
ricoh ac205 open heat error You have either a broken heat lamp, or thermostat (thermal fuse). Heat lamp PN G144 9731 and/or thermostat PN B273 7502
low heat error for samsung sf-565pr fax machine pl help check the fuser heat lamp during initalize ,if heat lamp not glow then check the fuser thermostate if open then replace the thermostate.
...Heat roller low temperature detection (HL2) ?The set temperature is not reached within the specified time (normally 3 min) when warming up or resetting from pre-heating. ?Under the ready state. (An ...
...heat lamp is good: Your best bet is to change all three items. (Temp fix) Fuser thermostat - thermal control device Fuser thermistor (middle front) - thermal control device Fuser thermistor (rear) - ...
what is sc 565 on a sp c820 SC565 *Heat lamp consecutive on error - Broken main fuser connection - Check HR thermistors - Heat roller lamp defective - Power Supply defective
...my samsung 4216f showing over heat detected and lamp in the fuser unit is not getting on You have a bad fuser unit. Since the copier does not complete the self-test process, the lamp does not turn
is there such a thing as a fixing lamp for a konica 7022 Fixing lamp is also called a heat lamp. It's the lamp that makes it hot enough for the toner to be fused (melted) on the paper.
152 questions posted
Usually answered in minutes!
534 Questions
436 Questions
284 Questions
267 Questions
262 Questions