Question about Konica Minolta Magicolor Office Equipment & Supplies
toner port. If you broke the tip of the tab off, you can use a drywall screw inserted into the Mechanical switch. when the door closes the bigger part of the tab will push the screw against the switch
Question about Konica Minolta Magicolor Office Equipment & Supplies
...toner box, drum unit then open 2 nipple screws and pull out the transfer pelt, if the belt looks ok, reinstall everything and power on again. if works, then everything is ok, if not, then there is ...
Question about Konica Minolta Magicolor Office Equipment & Supplies
...toner levels and it reports this accurately. So, I've tried everything - any ideas. Done cleaning it, replacing the switch. Toners all been taken in and out etc. /Andy P.S. I didn't fancy trying to ...
Question about Konica Minolta Magicolor Office Equipment & Supplies
for toner if empty replace from customer stock or have customer replace. 2. Broken toner lock pins on imaging unit. - verify the pins on Imaging unit that the toner cartridges lock into are not broken
...toner fits into the machine I recently had a customer break the piece that holds the toner in place. The machine symptom was that the toner did not lock into place like the other ones did.. GOOD ...
...toner door is properly positioned. Snap the door back into place at the two inner door-locking mechanisms (Figure 2). Figure 6: Inner door locking mechanisms Verify that the door hinge and upper ring ...
...Any advice for me? Thanks sound like the cartridge locks may have broke. This extremely common on these models. You have to take out the toners and look for broken pieces on the toner locks on ...
Question about Konica Minolta Magicolor Office Equipment & Supplies
...it often goes bad and tears. Hp should modify this and make this piece metal not plastic. You can manually pull and push down on the metal bar to lock unlock the toner cartridges for a temporary
Question about Konica Minolta Magicolor Office Equipment & Supplies
...toner lock is broken. Contacts on the left side of printer are damaged. There is a complete proceedure for replacing the the toner locks which comes in a kit you can order from precisionroller.com. ...
Question about Konica Minolta Magicolor Office Equipment & Supplies
...assistance would be greatly appreciated. It sounds like the part the toner bottle slides under to lock in place is broken. you could try and fold some paper and tape it to the toner to hold it
271 questions posted
Usually answered in minutes!
321 Questions
259 Questions
182 Questions
115 Questions
97 Questions