Behringer Ct100 Cable Tester "xlr pin connection" Questions

...pin 1 of the XLR to the sleeve of the TRS. Pin 2 of the XLR can connect to either the tip or the ring of the TRS and pin 3 of the XLR to the other TRS tip or ring. The line should be an audio ...

...XLR is connected to pin 3 instead of pin 1. The numbering of the pins are weird on XLR connectors with pin 3 at the APEX of the triangle. Cables MADE IN CHINA... I changed all the connections on site ...

...path signal, I found out the +positive signal bleeds to negative - #1 pin on XLR mic output. How can I block the the power from entering to the negative pin on XLR mic output. Ground the 3rd pin!

XLR pin configuration is correct (this if you make your own cable with XLR connectors). At the XLR connector, pin1 male connector must be connect to pin 1 female connector, and so on. If the hum still

...pin on the XLR to pin 2. That means that if you run this unit with US speakers your signal will be out of phase. Be careful there... I have lived this with AH boards before. You can also use normal ...

...pin positions here: ...

...xlr-jack cable but the manual staes that I should be getting a diagonal reading on the testers LED grid... Can anybody help?? This site has diagrams... not the best but clear enough. PLEASE note that ...

...XLR 3 pin type on the rear, intended for professional pa amplifiers which use balanced +4dbv line input level. Amplifier which have 3 pin XLR connectors for input signals can accept that high level ...

...is unbalanced and they would share a common ground lead.  XLR wired with one pin common with shield and right and left have a single conductor on the plug or jack, that is

...XLR connectors Pin 1 is ground/shield. Pin 2 is HOT. Pin 3 is cold. Measure pin 2 positive and Pin 1 to ground at the mic end of cable. See if you are actually are getting phantom. Balanced TRS ...