I have a 2011 ultra, my stereo will work great when the ignition switch is in the accesory when i switch it back to ignition I can not change functions, switch back to accesory and it works just fine..its driving me nuts!! the volume works fine in both positions and i am able to change radio stations in both positions but i cant switch to cd or aux while the bike is running, i have to shut it off and turn the ignition switch to accesory change my function restart my bike and im on my way..any ideas??
SOURCE: No power when I try to start bike, just a click…
Check the battery connections. Remove, clean and reinstall them. You probably had them off doing the wiring and they aren't making a good connection now. Always remove the negative first and install it last.
SOURCE: The speedometer has gone wacko on my 1998 Ultra (mech drive)
remove your speed sensor from the transmission and clean the metal shavings off of it
SOURCE: Bike wont Start.
You can accidentally UNPLUG the tip sensor if you remove/jar the front fairing. Verify that it is plugged in. If you uninstalled the tip sensor, make sure it is installed in the correct position. Here's the service manual next steps after that check: First thing the SM states when you turn the key and get no fuel pump "noise" is to inspect the fuel pump by measuring the voltage between the terminals. If there is battery voltage, check the main fuse (20A), sub fuse (10A), engine stop switch, fuel cutoff relay (relay box under left middle cowl), engine stop relay, bank angle sensor, and finally, ECM.
SOURCE: I just bought a used '03 650 vstar. I started it
Colud your room mate have accidentally put the bike in gear? There is a switch on the kickstand that will killl the engine if kickstand is down and bike is in gear.
SOURCE: left turn signal not working proper
Turn signals flashing is the confirmation of alarm system being on.I thought both sides flashed but if alarm is faulty guess that's messed up too. Try starting from stratch with alarm,disarm it[disconnect neg wire at battery]then reconnect wire and when that sets off alarm turn it off in normal way.That should get things back on track.Plus,try replacing the flasher unit,don't know why this works but I've heard of it.
150 views
Usually answered in minutes!
×