Turn signal replacement

Remove lens, disconnect wires inside assembly(take pic first) remove nut from back of post, pull off broken signal and replace

Motorcycle lighting OSRAM Automotive

download pdf list

cheak to make sure they are wired correctt it sounds like you might of crossed some wires does the indicatoer stay lite when the turn switch is off that would licnence plate light hooked into signal

Honda always grounds the turn signals separately (usually a green wire)not directly to the frame.Not hooking up the running light should not effect anything except forward visibility to other motorists. If you have a two prong flasher relay, go get a cheap flasher relay ($5-$10) and replace it. The only problem I have ever heard of when switching to LED turn signals is a flicker / fast flash instead of a normal slow flash. This is remedied by adding diodes to the wires.

sounds like your ground wire is off. check that first. they do have a turn signal blinker also. also try replacing the bulb.

hope this helps

Hi and welcome to FixYa,

Honda in general uses standardized wiring scheme:

• green - common ground;
  
• light blue - right turn signal;
  
• orange - left turn signal.
  

Good luck and thank you for asking FixYa.