Cars & Trucks Logo

Related Topics:

Posted on Aug 04, 2008

Parking lights won't go off on hyundai xg-350

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Feb 09, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Feb 09, 2010
Answers
1
Questions
0
Helped
367
Points
1

I can't get the parking lights to go off on my Hyundai XG350

5 Related Answers

Anonymous

  • 350 Answers
  • Posted on Sep 30, 2008

SOURCE: 2002 Hyundai XG 350L Check Engine Light w/o a code

hi the check light has a short could be expensive to fix or not trouble nowadays electronic componts are tempermental so have you got your code for your radio as the soultion to the problem could be as simple as disconnecting your battery for 10 minutes and reconnect this will reset your ecu unit and any abnormall glitchs in the computer trouble is you will lose your codes for the radio this is something that is rare but i have come across before running the car without the check light working only tells you if the emmissions system is working or not the car will run fine as it as a back up system so if the cars not giving you any problems it will be ok but this should work if not then check the wiring from the light and the ecu yates210456

Ad

Anonymous

  • 2 Answers
  • Posted on Dec 17, 2008

SOURCE: Heater/AC Quit working

Check the fuses first then check to see if you hvac (heat, vent,a/c) control switch is bad by check the signal voltage.

Anonymous

  • 776 Answers
  • Posted on Jun 02, 2009

SOURCE: ac compressor will not engage 2003 hyundai xg 350

You found the problem (lost ground on relay)... Fix it! You solve this problem yourself.

Anonymous

  • 776 Answers
  • Posted on Jul 18, 2009

SOURCE: HOW TO CHANGE A/C COMP. BELT

loosen tentioner pully belt... using a 14 mm wrench, release tension on the belt by loosening the 14mm bolt. when loose enough, remove belt.. then install NEW belt.. adjust tension on new belt then tighten 14mm bolt on tensioner pully... you're done.

Anonymous

  • 613 Answers
  • Posted on Sep 24, 2010

SOURCE: How do you remove the rear view mirror on a

they are just glued on pull them off then when replace buy rear view mirror glue couple bucks but takes special glue

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers
1helpful
1answer
0helpful
1answer

On m a 2004 hyundai xg 350 i in have a check engine light that TN won't clear. I've hooked a diagnosed reader it shows code PO136 O2 sensor circuit bank 1 sensor 2. I I have replaced that sensor & i...

After fixing you sometimes need to delete the fault codes that er registrered on your ECU "electronic control unit, or car computer". You do that by using the ODB device and on that device select to delete fault codes.
0helpful
1answer

Locate the starter

The starter motor will engage the gear in the transmission bell housing to rotate the engine, so it will be mounted on the side of the transmission. The illustration shows the XG-300 and XG-350.


10_1_2011_2_37_23_am.jpg
0helpful
1answer

Sudden aceleration

I also own a 2004 XG 350 and am a Plaltinum Certified Technician. My best guess would be the APS (Accelerator Position Sensor) malfunction. However, if the malfunction lasted long enough, the "Check Engine" light would illuminate and set an APS code. Best advice -- have it properly diagnosed by a Certified Hyundai Technician (there just might be other/pending issues).
0helpful
2answers

2004 hyundai XG-350 Check engine light is on and

Sorry Peter I do not have a solution to your car problem, but I also own a 2004 XG-350 and the SAME EXACT thing is happening to my car right now, crazy huh. Pretty much started out of nowhere...the boyfriend is going to go try the leaving keys in ON position and reconnecting the battery. Did you happen to find out what was wrong with yours, thought maybe if you did it would help save me a step. Praying nothing to serious. Hope you got your car working well again!

Thanks,
Nikki
0helpful
1answer

2002 XG 350. License plate bulb out. How do I pull bulb, wiring is too tight. Thanks Joe B

2002 HYUNDIA XL 350, LIC. PLATE BLUBS CAN NOT GET ASSEMBLY DOWN TO REPLACE BLUBS, DUE TO THE FACT THE WIRES ARE TOO SHORT TO PULL UNIT DOWN. ANYH IDEAS?
0helpful
1answer

DTC 1159 what does this mean on a 2003 hyundai xg 350

varible intake motor malfunction. take it to the dealer, unless you have expertise and tools/test equipment to work on this car.
1helpful
1answer

Ac compressor will not engage 2003 hyundai xg 350

You found the problem (lost ground on relay)... Fix it! You solve this problem yourself.
0helpful
1answer

2003 Hyundai XG 350 will not start

Hooked new battery up, alarm went off, waited until it stopped, locked car with fob then unlocked and the car started.
Not finding what you are looking for?

377 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...