I am installing a chip and cant located the IAT in my 2009 ford mustang. please help. if it was located somewhere else please describe in full where that is located too thanks!

See if this helps -

94 ford ranger mass air sensor the iat sensor

idle air temp sensor

The IAT is integrated with the MAF sensor on the 09 Fusion. The MAF is located near the air box on all three engines. on the driver's side, and will be held to some part of the intake tubing by 2 torx screws. http://media.photobucket.com/image/2009%20Fusion%20MAF/itsamecameron/fusion4cylengineMAF.jpg 2.3L shown, 3.0 and 3.5 should be similar.

The iat looks like the mass air flow its a hard plastic cylinder that connects to the intake tube after the air cleaner

BE CAREFUL.... If the part you are installing is the .19 Cent diode you should really understand what it does and if it was really that good an idea, don't you think Subaru would have done it at the factory. There are alot of Ebayers that are making a killing off of selling the .19 cent diode and a piece of paper with directions for about $5 a pop.

sometimes the air temp sensor is in the mass air too.

It's built into the Mass Air Flow sensor. pls rate the solution if satisfied

please rate as problem solved if this is what you need.



Section 03-14: Engine Controls, Electronic 1994 Mustang. Workshop Manual
REMOVAL AND INSTALLATION Intake Air Temperature (IAT) Sensor Removal and Installation

1. Disconnect battery ground cable (14301) .

1. Disconnect engine control sensor wiring (12A581) from intake air temperature sensor (IAT sensor) (12A697) .

1. Remove intake air temperature sensor from air cleaner outlet tube (9B659). (This is the tube that goes from the air cleaner to the engine.)

1. To install, reverse Removal procedure. Tighten intake air temperature sensor securely.

--------------------------------------------------------------------------

can you please describe your problem more in detail? I have the same car and also have a kenwood cd player installed.. what wires are u looking for?

The IAT sensor should be located in the air inlet tube to the throttlebody