At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I had the same problem and your right no egr on 2005 town and country I have the same vehicle and the place for the egr is covered by a metal plate I also had the same exact problem with my van misfire bad idle at stop lights and after replacing every sensor there is and testing every part and injector with Ohm meter I read an article about the intake manifold plenum gasket leak can cause misfire so I bought new intake manifold plenum gasket set for only $7.99 and installed them and like magic the van ran perfect no more misfire no sluggish start from light Van is fixed finally!!!
by dillardw I had the code po406 in my 2005 chrysler town and country. I is problem in the EGR valve. I replaced the EGR valve. the valve is by the alternator on the 3.3L engine and has a tube going up and into the intake manifold on top of the engine. The valve cost $ 65.00 in 2008 at the dealer with discount it was cheaper than two after markets that i checked. I erased the dtc from the computer and have had no more problems with this. Of course the problem could be different on your vehicle. I hope this helps.
Maybe you meant a P0406? That is an EGR code. It could be the EGR valve, solenoid or a wiring issue. Check that code again, P codes are always followed by 4 numbers.
P0404 IS EGR POSITION SENSOR PERFORMANCE..YOU NEED A NEW EGR VALVE..RECOMMEND DISCONNECTING BATTERY WHILE REPLACING EGR VALVE..SOMETIMES CODE WILL NOT GO AWAY EVEN AFTER REPLACING VALVE AND CLEARING CODE WITH SCANNER..VALVE IS LOCATED ABOVE ALTERNATOR ON END OF CYLINDER HEAD..THE BOTTOM BOLT CAN BE TRICKY TO REMOVE AND HAVE HAD TO REMOVE ALTERNATOR TO GET BOLT OUT..YOU WILL NEED A NEW GASKET FOR TUBE AS WELL..ABOUT 120 BUCKS FROM DEALER(CAN)
this is an egr valve trouble code..you need a new egr valve..make sure you disconnect battery when you replace it..sometimes fault will come back even though replaced valve
2001 Chrysler Town and Country- Won't start. Turn over. It acts like the fuel is not getting to the engine. After many attempts , it starts and runs like there are no problems. The car has 120,000 and has never had a problem. Is the fule pump bad?
×