I am trying to change the brake discs on my 2007 T&C Touring. There is a clip on the...
(More)
I am trying to change the brake discs on my 2007 T&C Touring. There is a clip on the outboard that connects the caliper block to the mouting bracket. How do you remove this clip? Also, does anyone know where I can get step by step procedure to change the front and rear discs? Thanks.
ABS warning lights come on when road is wet and after I drive approximately 5 miles. Goes off when I...
(More)
ABS warning lights come on when road is wet and after I drive approximately 5 miles. Goes off when I shut car off and wheels dry, then back on when driving on wet roads. 2007 chrysler minivan, town and country
my 2002 chrysler town and country is blowing extremely hot air out of driver side vents even when...
(More)
my 2002 chrysler town and country is blowing extremely hot air out of driver side vents even when temp set to 59 degrees...other vents work according to what they are set on. I have ATC...PLEASE HELP!
my 2007 town and country was broken into and they broke out the ignition. they could not start the...
(More)
my 2007 town and country was broken into and they broke out the ignition. they could not start the car but now when i put the ignition back in my car started than stalled ( i know it is a safety thing ) but will my key ever reset or what?
How do I pull out the cd changer in my 2004 town and country. I think there is a disk stuck in it. I...
(More)
How do I pull out the cd changer in my 2004 town and country. I think there is a disk stuck in it. I loaded a cd and it started making clicking sounds, now it only plays the one cd and I cannot eject it or change it. I'd like to pull it out and see if something is stuck.
2008 Town & Country with P1607 code on OBD II code. Upon startup it idles high then idles...
(More)
2008 Town & Country with P1607 code on OBD II code. Upon startup it idles high then idles down to where it should be. When I got the oild changed, mechanic recommended injectors to be cleaned. I bought this vehicle brand new. Currently has 15900 miles.
I have a 99 Chrysler T&C. Key will not turn in ignition. Steering is not "locked"....
(More)
I have a 99 Chrysler T&C. Key will not turn in ignition. Steering is not "locked". I tried WD-40 and no help. Any suggestions? Same thing happened a few months ago, and after WD-40 all worked fine.
01 chrysler van power side and rear hatch will not fully open When I use the key fob it will unlock...
(More)
01 chrysler van power side and rear hatch will not fully open When I use the key fob it will unlock and then not move but an inch or 2 The rear hatch will not move at all
1999 town & country van. While driving the power locks go off & on and now my alarm...
(More)
1999 town & country van. While driving the power locks go off & on and now my alarm is going off when the car is turned off. Is there a fuse I need to change?
i have to keep trying to crank it but after the third try it would crank and stay crank all that...
(More)
i have to keep trying to crank it but after the third try it would crank and stay crank all that until that night without me having any problems until that night
this is a tip for all those who are looking for free diagrams, free diagrams are very hard to get... allthough most of us have access to diagrams,...
written by jaysonemanme
This is the reset proceedure for a 2008 Highlander with a key-type ignition: Turn the key ON, do not start the engine. Look at the odometer, and...
written by Toyota Ed
There is a known issue with the 2005-2007 Corolla automatic transmission shift logic. The shift points may seem harsh, and the Check Engine light may...
written by Toyota Ed
There are two jam switches located on the latch assymbly. One on top and one at the bottom. They can become dirty and not function properly causing...
written by dlmcmasters
Believe it or not, it is normal for these engines to use about a quart every 2000 even when they are essentially new. Note that I said,...
written by chiquititas
I will explain this better! Turn off the radio and turn the key to the on position. Press and hold DISP knob, when info comes on window press the seek...
written by DAD5bbbbg