Screw off the cover of the head light until it reach the head light then screw of the head light to be place out to the car then open the head light then replace the the light.
SOURCE: 2004 chevy Malibu front struts
no but be carefull lots of pressure in those spring good luck pierre
SOURCE: Replace Dash light bulbs on 2004 Malibu Maxx
you need to take the hole dash out and on the back of the speed dash there are little bulbs take them out then replace them
SOURCE: steps to replacing right front signal light bulb in 2005 Malibu
Raise hood and remove two hex bolts holding light assembly. You will see three round rubber covers, approximately 4" in diameter. Unscrew the one to the far left, giving access to the signal light bulb. The bulb pulls straight out. Insert new bulb, replace rubber cover, attacht light assembly back to vehicle with hex bolts, close hood, and pat yourself on the back for job well done.
SOURCE: trying to replace light bulbs, front and rear
No usually for GM vehicles there are two pins on the headlight that you pull out and up. they are L shaped upside down. If not there are bolts holding the headlights on. But no special tool needed, it is a simple job, once the headlights are off twist the bulb counter clock wise, if they have a notch depress it and remove the bulb unhook it from the harness and you are done. Installation is reverse of removal.
381 views
Usually answered in minutes!
×