Low beams are not working, bulbs OK. What are failure modes for this problem; could be similar to NHTSA recall for 2005 Pacifica
SOURCE: Changing low beam headlight bulb on 2005 chrysler sebring
you can change the passanger side with little difficulty however the drivers side you need to remove power cell from it's bracket and move aside in order to access light.
SOURCE: 2005 pacifica w/ HID headlamps driver side doesnt work
From LustyKid.
Check the connector wire for continuity on the low end side with a good OHM meter. You probably have a broken wire connection but can't see it due to insulation. See if you have voltage on the low end side of the plug. No voltage, no light. Probe the wire and find where the current stops. Also make sure you don't have the ground reverse on the plug to the headlight. Before replacing it of course. Or you can cut all the wires and replace with a new connector.
SOURCE: how do you replace the headlight bulb on a 2001 chrysler lhs.
This can be done buy popping the hood and removing the bulb from the rear of the headlight housing. don't screw with the housing because, its leveled for optimal sight range.
SOURCE: changing headlight 300m
lift the hood. the light are down behind the light assembly. simply turn large black ring and it will come out. be carefull not to touch the glass on the new one. oil from your skin will cause it to prematurely fail.
SOURCE: Left low beam headlight on Chrysler 2003 T&C wont work while engine is on
Ill guarantee you have an electrical short on the left side of the headlight switch,circuit.From here its immpossible for me to go any further.Good Luck.,Get A Wiring diagram.
494 views
Usually answered in minutes!
×