- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
to remove your serpentine belt and alternator you will need a long 3/8 drive rachet or a special tensioner remover set you can rent from autozone. then you need a rachet set from 10 mm to 15 mm,
before to do anything you have to dsiconect the battery, startin with the negative cable (-) then the positive (+), then remove the big wire from the alternator, removing the nut (10 or 12 mm) then the electric conector ( unlocking tab). then look for the tensioner , at the battom of it it has a square hole where you need to insert the 3/8 drive tool or rachet, pull to the right, you will see the serpentine belt begin to be loose. remove the serpentine belt and alternator by loosing the bolts that are attached to the alternator. to install it folow the same. but backwards. good lock
Hello josecarrion3: My name is Roger and I will help you. I attached a picture of the belt routing for you. Should You need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger
Click on the following: free, direct Link. It has several Diagrams including the Serpentine Belt Diagram for your 2004 Chysler Pacifica 3.5L DOHC V6. It has the Instructional and Directional Diagrams that will help you.
Standard Rules for Installing the Serpentine Belt with an Automatic Tensioner: a. Pick a Pulley that is most easily accessed. This will be the last Pulley that the belt will go on. b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left right. c. Using a Serpentine Belt Tensioner Tool or Wrench (See Diagram in Link: Rotate/Move the Tensioner Pulley/Arm "away" from Belt contact area on the Tensioner. This spring is pretty hard and with a new belt, it will be even harder to install. Rotate/Move this to as-close to the maximum allowed inorder to have enough slack in the belt to get it up and over the last pulley. d. Using your other hand - Pull the Belt up and over the Last remaining Pulley. e. Before releasing the pressure on the Tensioner, visually inspect the remainder Pulleys and the Belts' Positioning on them. Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!