20 Most Recent 2001 Dodge Grand Caravan Questions & Answers


It's a internal issue servo or band broken

2001 Dodge Grand... | Answered 19 hours ago


Cover under dash at drivers feet, black in color, remove it to expose fuse panel.

2001 Dodge Grand... | Answered on Apr 13, 2019


Testing the fuel pump electrical circuit should be done , voltage drop testing . Plus fuel pump pressure an flow testing , scan engine data parameters .
Testing Electric Fuel Pump Problems with Voltage Drop Test
048 Engine Hard to Start or No Start Scan Data for Starting Problems

2001 Dodge Grand... | Answered on Sep 16, 2018


I suggest you get one of those manuals people get nowadays
to do it yourself.. My nephew use it to repair my car and it's totally repaired now. Here's the website he got it from. www.reliable-store.com

2001 Dodge Grand... | Answered on Mar 07, 2018


It has 2 feeds.If you run a ground to the ground side of the relay,engine turns over but doesn,t run ????? The PCM - engine computer isn't supplying the ground for some reason . Anti-theft system problem . Disables fuel an starting systems . Have you checked for codes ?DTC'S - diagnostic trouble codes .

2001 Dodge Grand... | Answered on Mar 04, 2018


check vacume lines unless it opperates with a cable might have come undone

If you need further help, reach me via phone at https://www.6ya.com/expert/scott_8b3f0f0fc5f566a7

2001 Dodge Grand... | Answered on Mar 03, 2018


The FCM -front control module could be the problem. It is attached to the PDC (power distribution center). Both units combined. it is called an IPM (integrated Power Module). Without testing is would be just a guess . Your best bet , take it to a qualified repair shop an have it diagnosed .

2001 Dodge Grand... | Answered on Feb 17, 2018


2001 dodge caravan
Wiring, schematic, electrical diagrams etc are basic contents of these online books they sell here on this website link I have attached. Must check it out

2001 Dodge Grand... | Answered on Jan 26, 2018


It is located near the Thermostat housing on the lower intake
manifold.

8_4_2012_5_36_47_pm.gif

2001 Dodge Grand... | Answered on Jan 05, 2018


Usually it is a seal on the radiator coolant tank. The plastic end tanks are sealed onto the aluminum radiator core with a rubber o-ring seal. Inspect up and down the radiator end-tanks.

2001 Dodge Grand... | Answered on Dec 29, 2017


depending on what door it is check the switch in the a post of the b post if its back doors. also known as the light switch, remove switch and clean the switch switch cleaner or well known brand wforty, or leave switch on remove the rubber seal and spray in the switch as you push it in do this a few times and flick the switch a few times.

2001 Dodge Grand... | Answered on Dec 21, 2017


It sounds like you may have a bad head gasket, causing normal mechanical compression to pressurize your cooling system. This would be an internal leak with no external visible symptoms. This could have been caused by a recent overheating, but some engines are more prone to this as "normal" aging.

Your auto parts store can test a sample of your coolant for by-products of combustion, just make sure the sample you provide isn't fresh coolant you just added. You'll need to run the engine long enough to get up to normal operating temperature, but don't drive it regularly until you get this problem fixed.

Sometimes coolant will mix with your oil when head gasket is bad, but not every time. If your oil level is high and the oil looks like chocolate milk, it's extremely likely the head gasket is bad.

A compression test will also pinpoint the "bad" cylinder, typically 2 cylinders will show low compression, but not always...but at least one will be low. If it tests as a bad head gasket, you will need to replace both if it's a V6 or V8 for a thorough repair, and have the mating surface of the heads resurfaced.

2001 Dodge Grand... | Answered on Dec 05, 2017


It could be the motor, but first i would check the wiring connector at the blower motor and the resistor. They could be melted. Turn it on and very gently wiggle the connector or wires near the connectors and see if that makes it come on.

2001 Dodge Grand... | Answered on Nov 09, 2017


If the noid light is working, the pcm is good. Why do you say it burned out? I would check ac voltage at each injector with engine running. If #2 has lower voltage than the others, you probably have a bad wire or connector.

2001 Dodge Grand... | Answered on Nov 08, 2017


it only takes senthetic atf+4 sound like the clutches are slippind

2001 Dodge Grand... | Answered on Nov 04, 2017

Not finding what you are looking for?
2001 Dodge Grand Caravan Logo

1,355 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85111 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Grand Caravan Dodge

  • Grand Caravan Dodge

Most Popular Question

freez plug 2001 grand cavban 3 8

  • Cars & Trucks
Loading...