How do you reset ABS light on 2003 Camry? - 2003 Toyota Camry

If that light is on there is a code, you did read this with an ABS capable scan tool? an engine code reader tool will not read the ABS control module

The ABS fault light will stay on until the problem is repaired, read the fault code and diagnose it again.

hi . if the abs light is on its usually a sensor that's gone down.if so will need to be changed. before light goes off. after reset.

have you tried disconnecting the battery again?

Track/traction light comes on when the ABS gets activated, the reasons could be low air pressure in tires, diffrent size of tires or VSS vehicle speed sensor wire loose or broken. If the rotation of tires are not the same the ECM thinks the vehicle is going into slip and activates the ABS so the driver can stear easier. ABS could also kick in if its raining or snowing.

ABS was optional on the 97 Camry CE - some have it, some don't. If your car is equipped with ABS, you should have an ABS indicator light on the dashboard, that goes on when you first turn the key in the ignition. But if you are not able to determine whether your car has ABS, it's not a problem. The axles compatible with ABS will also work if your Camry does not have ABS. They cost about the same as axles without ABS. So if you are not sure, just buy the axles for ABS.

need to know if Bosch or Denso.

its is the abs comp

i have a 2003 toyota 4-runner my brake and abs vsc are on and it has a beeping loud noise.....what do u think is the problem?

Hi

This could be a dirty or faulty wheel sensor, a faulty ABS pump, or a faulty ABS computer.

You could try cleaning the wheel sensors by spraying them with brake cleaner, and if this doesn't rectify the problem then a garage can read out the ABS fault codes and tell you what the problem is.

Sometimes just a reset is enough to clear it.

Regards

Geordie