The "service traction" message appears on the info center. The "TC" indicator also lights. After approx. 20 miles the "check engine" indicator also came on. I checked the gas cap; it was on correctly.
SOURCE: power steering cap location Pontiac G6 3.5L
it is located on the passengerside under the altenator closest to the firewall. make sure the vehicle is turned off reach in under the altenator and you should feel the cap.
SOURCE: service engine soon light on
you need to put it on a computer to find what the code is such as on o2 sensor or a number of other things. once you know the codes you can fix the problem
SOURCE: transmission fluid for 2007 pontiac G6 GT
This car does not have a auto trans dipstick, the level can only be checked by the dealer, this is a growing trend that started with most German cars, the filter is inside the trans pan and only needs changing every 60,000 miles.
SOURCE: Changing blinker on 2007 Pontiac G6
It's a monster pain to get to them, but it's doable. Once you empty the trunk, you'll see 4 black knobs - approx 1.5 inches in diameter. You'll need to remove all of these (they just unscrew, but they are plastic, so be careful not to strip the threading) in order to access the rear light assembly.
They're in there snug, but once you find the appropriate sized socket (I wish I could recall well enough to tell you what size, b/c I remember that it WAS an odd size), you'll have to remove all 3 bolts and then push the whole assembly out from inside the trunk.
Once the assembly is out, you will see the rear of the sockets, which simply push and turn to get the lamps out of. As long as you have everything open, I suggest changing ALL of the lamps (brake, tail, and turn signal) on BOTH sides, since the lamp life for all of these is about the same and it's such a pain to get to them in the first place.
SOURCE: replace the pontiac G6 center console light
You should be able to open the cover piece that holds both lights. This piece if you take a flat head screwdriver carefully, just pry the plastic cover (not the actual push buttons), and release it. You should now have access to the lightbulbs for replacement.
2,775 views
Usually answered in minutes!
×