Anonymous posted an answer for this Radio Communications:
"just replace with same ohms.....replace example--- 100k with 100k 5k with 5k etc......any..."
Anonymous posted an answer for this Radio Communications:
"Hi, i've got an astatic mobile max echo chamber but the echo and echo volume controls are..."
Anonymous posted an answer for this Radio Communications:
"galaxy dx959 the channels are not same as on my superstar 121 cb radio. the low,high..."
Anonymous posted an answer for this Radio Communications:
"Nothing you can do"
Anonymous posted an answer for this Cobra Radio Communications:
"ALLways start with ground. Find ground on radio pin with ohm meter. EVERY thing operates..."
Anonymous posted an answer for this Cobra Radio Communications:
"I have a cobra 148gtl with 5 pin side plug for mic.Im trying to wire a superstar dm 1000..."
Anonymous posted an answer for this Cobra Radio Communications:
"Start with checking electrolitic capacitors...radio is OLD.....check caps. for shorts then..."
Anonymous posted an answer for this Radio Communications:
"It does on ssb but just a carrior signal on AM. Please help! thanks ,Bob"
Anonymous posted an answer for this Radio Communications:
"I've got a Johnson Viking 352, in very nice condition. The problem is, It will transmit on..."
Anonymous posted an answer for this Cobra Radio Communications:
"check your Audio Output tansistor.....check ALL electrolitic capacitors.....Start with..."
Anonymous posted an answer for this Cobra Radio Communications:
"Hello I have a Cobra 2000 GTL that transmits a strong carrier with no modulation on..."
Anonymous posted an answer for this Cobra Radio Communications:
"sounds like your Audio Output went out......not audio chip....may be your voltage..."
Anonymous posted an answer for this Galaxy Radios DX-959 40-Channels Base CB Radio:
"LED are diodes that operate around 2volts DC. A resistor must be soldered in series with..."
Anonymous posted an answer for this Galaxy Radios DX-959 40-Channels Base CB Radio:
"Hi, does anyone know how to connect an LED to replace the original meter lamp on a Galaxy..."
Anonymous posted an answer for this Cobra 148 GTL 120-Channels Base CB Radio:
"Magnet mounts do not have a true ground.....try grounding chasis of radio to circuit board..."
Anonymous posted an answer for this Cobra 148 GTL 120-Channels Base CB Radio:
"Have not used my cobra for some time ...sine someone need my K40 antennae more than me...."
Anonymous posted an answer for this Radio Communications:
"Voltage of the backlight on the Kenwood TS-60 Need to replace the backlight on the Kenwood..."
Anonymous posted an answer for this Radio Communications:
"check voltage of existing wire leads....any 12 volt wheat lamp will do or use resistor..."
Anonymous posted an answer for this Cobra 29 LTD CB Radio:
"check 8 volt regulator"
Anonymous posted an answer for this Cobra 29 LTD CB Radio:
"COBRA 29 NW THE NIGHTWATCH DISPLAY STOPPED WORKING"
Anonymous posted an answer for this Cobra 29 WX NW ST 40-Channels Base CB Radio:
"Truck one, the radio has no sound but the needle moves with someone talks. Truck two, the..."
Anonymous posted an answer for this Cobra 29 WX NW ST 40-Channels Base CB Radio:
"Sounds like bad external speaker"
Anonymous posted an answer for this Cobra 25 LTD 40-Channels Base CB Radio:
"i just unsodered the pll chip on my cobra 25 ltd classic and popped it out and dont..."
Anonymous posted an answer for this Cobra 25 LTD 40-Channels Base CB Radio:
"On the circuit board where your chip was you will see that there is an indentation on one..."