Nike Watches - Page 6 - Recent Questions, Troubleshooting & Support

I had to take the following steps to get it to work in Windows 7 after running the setup executable under the Comments in the Windows row from http://www.ftdichip.com/Drivers/VCP.htm

1. Open up Device Manager, right click on the Triax Elite and select Update Driver Software.
2. Select "Browse my computer for driver software" in the window that pops up.
3. Click "Let me pick from a list of device drivers on my computer."
4. Scroll all the way down the list of "common hardware types" to USB controller.
5. Choose FTDI from the list of manufacturers and choose the "USB Serial Converter"
6. Confirm that you know what you're doing and want to install this driver.
   

Windows then finds another Unknown Device which is the serial port. Repeat as above but choose Ports for the common hardware types and then FTDI and "USB Serial Port".

Afterwards, run the latest Nike Triax Elite software (that you can download from http://www.nike.com/timing/extranet/elite_software/ and it should work.

i have the same problem... did you find any solution?

Hold the right upper button for a few seconds and than release it. The light button will work!

Hold the right upper button for a few seconds and than release it. The light button will work!

I want to buy the strap of your watch. Contact me, please.

If you don't have the instructions, the buttons are labeled as follows:

Top Left is "Light" - Button A
Bottom Left is "Mode" - Button B
Top Right is "Start" - Button C
Bottom Right is "Reset" - Button D

With the time displayed, press the reset ("D button as listed in the instructions) and the alarm time should be displayed. While holding the "D"/reset button down, press the start or "C" button to toggle the alarm on or off.

Hope this helps