Question about CCTUBEGN 12.5''TUBE Fluorescent Lamp Kit
...4) Strip 1/2" of insulation from the ends of the wires. 5) Mount the component and connect the wires with wire nuts. 6) Replace the cover and tube. 7) Turn the circuit back on. 8) Turn the switch
...Lamp cover is not fastened securely - No picture/No sound Fan error 4 times - Fan1-4 Power is not supplied.(G2 board) - Fan connector is not seated securely - Fan caught wires or harnesses - No ...
...4" from the wall and someway to vent out hot air and get cool air in. a different model had the temp sensor cause this issue, it is the silver thing right atop the lamp. you will have to pull the ...
Question about HLN5065W 50" Rear Projection HDTV-Ready Television
...4 screws through the jack panel that hold the left-side chassis to the cabinet. Remove these screws. Also, there are two screws mounted vertically (one on either side) of the jack panel that hold the ...
Question about HLN5065W 50" Rear Projection HDTV-Ready Television
...wire connected to it that is a thermometer. If that is unplugged the lamp will also not fire. So, requirements for fire lamp: 1. Power from power supply board to ballast 2. Ballast converting power ...
Question about 2 Person Spa Hot Tub 8 Hydrotherapy Jets 3/4 Hp Pump
...4 prongs on it. The cord comes from the power pack to the u/v unit. The hot conects to the transformer, the nuetral goes directly to the light. The out wire from the transformer goes to the light . ...
Question about PT-52LCX65 44" HDTV
...lamp 4 months ago Our TV is almost 5 years old. Back in October we replaced the lamp after it popped. Everything was fine for a month or two. Then, we started getting the notice that it was time to ...
Question about DLA-X3 Procision Projector
lamp fan and air duct. At the center is the lens assembly and motors for focus lens shift etc. on the left are stacks of electronics that are stacked board on board of about 4 or 5 layers. this is the
...wire to lamp; Lamp Cartridge Failure Code 34(1) - Lamp Enable is generated to activate the Lamp Code 57(2) - Lamp Enable is generated during P-ON sequence, but no Lamplit signal is received from the ...
Question about DLA-X3 Procision Projector
wire in FB cable is for power on tv and dlp system. thanks for your help ... fb cable= 1- lamp LIT 2- GND 3- +5vs 4- lamp _EN 5- DIM You are going to ruin the optics using a Xenon lamp. The ballast in
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions