...key to the start position...volts should not drop below 9.5v. If it does, have battery load tested. If it passes, then either starter is drawing too many amps and needs to be replaced, or ...
1998 toyota tacoma P0302 Cylinder 2 Misfire Detected Need help? do a compression test on the engine.if that checks out ok then the problem is either an ignition problem or a bad fuel injector
...Tacoma (2011 and newer vehicles must be programmed by a professional automotive locksmith or dealership) 1. Start with the key out of the ignition, drivers door is open, all other doors and trunk ...
Question about 2004 4Runner
TACOMA V-6/ A/C LIGHT BLINKS, COMPRESSOR NOT WORKING I think its a bad relay, but not sure. pulled wiring plug at compressor and with ignition on and switch on tested all 3 wires with a test light, no
...check starter it passed. did light test and the ignition switch is bad. How do you change an ignition switch? I have a 2002 toyota tacoma 2 wheel drive My key is stuck in the ignition and will not ...
...test 95 Tacoma 2.4L internal distributor coil You may need a shop manual for the procedure. The black and red wire should be hot from the key. Other than that, you would need to know which wire ...
2003 toyota tacoma won't start battery seems fine, no turning over though What was checked/tested ? Fuel pressure at motor & spark cranking? Battery seems fine based on what kind of testing? ...
Question about 2005 Tacoma
...ARE FINE, CD PLAYER IS NOT WORKING EITHER,BUT IT WAS BEFORE. THANKS IN ADVANCE are you sure you tested all fuses there should be a 5 amp fuse for the ecm or pcm as well all the fuses inside car
Question about 2005 Tacoma PreRunner
...Tacoma prerunner 4.0 1. Relearn the idle speed by disconnecting the EFI fuse and the ECTS fuse from the under hood fuse box. Leave the fuses out for 2-3 minutes minimum. Reinstall the fuses. Using ...
Question about 2005 Tacoma PreRunner
...test on a 1998 Toyota Tacoma Do you have compression guage and fittings? How To Perform Compression Test EricTheCarGuy To do a compression test you will need a compression tester. First remove each ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions