Questions & Answers for: Fisher and Paykel spigot

...below it. There is a clear tube coming up from the outer tub and it pushes onto a small plastic spigot on the right side of the board. Pull this hose off and blow through it. If there is any ...

...beeping until the machine is turned off. Any help would be greatly appreciated Check your exit hose spigot, it may be clogged. This is if your filter is all clean. There should be air for passage in ...

...The F1 code is the flooding error code (I changed the the sink drain pipe and forgot to drill the spigot out for the dishwasher - so make sure they did that on install ok . The only information I ...

...was the problem but this also hasnt solved my problem.... Can anyone help? Check your exit hose spigot, it may be clogged. This is if your filter is all clean. There should be air for passage in ...

...to see if water flow is good at your wall faucet, coming into machine. Then check your exit hose spigot, it may be clogged. This is if your filter is all clean (ref manual). There should be air

...GW712 hot water fills fine - cold water just trickles. Was working fine until yesterday Turn that spigot off, then unscrew the hose from the machine and inspect the screen that is there (on most ...

...died at the same time, look under your sink where the drain hose attaches to the little drain spigot that comes off the pipe work (this is assuming that's how you have it setup as most ...

...level is reached so agitator can turn freely. If any of these it could be bowl or spline drive and

...small plastic lever that actuates it from the front panel had slipped off the side of the button spigot and was jammed beside the spigot. Unscrewed the PCB behind the front panel to free the lever ...