Printing problems When the printer is turned on the cartridges slam back and forth and then still will not print. The light blinks on and off on the printer. I've seen the head banging problem before.
Lexmark X1185 won't Print Color I purchased A NEW Lexmark #27 ink cartridge, properly installed per instructions, however still not printing color, black printing is OK. My question-what could be the ...
Paper sensor, I think Lexmark Z23, over 6 years old, suddenly stopped printing. Power light is on, steady, and will not turn off. Paper feed light is blinking. There is no paper jam visible. It is ...
Blinking light The power light continues to blink despite my efforts to turn it off. The printer will not print. I reseated the color cartridge and--Bingo!--the light quit flashing and the printer ...
Question about Color JetPrinter Z23 InkJet
printer not printing model z2300 on light is flashing i had to disconnect my printer and reinstale but the test page didn't print and i cant get anything to print. the green on light is flashing all ...
My Lexmark X1290 is not printing clearly. Print has blank lines through black. Color is not printing yellow, red is light, blue appears to be OK I have the same problem. I thought the yellow might be ...
Z11 Printe Cartridge Stuck Replaced the cartridge and had to load up the driver. The system asked to run an alignment process and proceeded to push two pages out of the printer with no printing. The ...
Question about Color JetPrinter Z32 InkJet
printer will not print. power light and feed light blink on & off installed refilled color cartridge. cancelled several print commands midway, because color was not printing. found the source of the ...
When I turn on the printer to power both lights are permanently lit and the printer will not print. Is blocked. Tx. Try to open the printer and remove the cartridges. Close the cover. Unplug the ...
powe light blinks off and on and printer wont print The printer is not communicating with your computer. What you need to do is to press and hold the printer's power button from 5-10 seconds until it ...
Usually answered in minutes!
542 Questions
147 Questions
54 Questions
43 Questions
38 Questions